|
| Stevo |
|
|||
|
On my old EF the cruise died, turned out to be the Brake Switch. (brake lights also werent working
 )
|
|||
| Top | |
|||
| Disco Frank |
|
|||
|
RJ-3820 wrote: id say sell it and buy a FBT..... but anyway......
yes welll we all know what happened there
_________________ RIP SCOTT |
|||
| Top | |
|||
| KeeddleZ |
|
|||
|
the brake light switch and the cruise brake switch are they the same switch?
_________________ 360 CL Lebaron
|
|||
| Top | |
|||
| zacha001 |
|
|||
|
Yeah i think so
My break lights are woking but the cruise isn't. My car is getting a service tommorrow and the cruise is hopefully getting fixed, so ill ask what the problem was. Cheers
_________________ 96 Fairmont
|
|||
| Top | |
|||
| KeeddleZ |
|
|||
|
snap0964 wrote: The areas that can cause what you have:
1. Brake pedal switch - okay as you have said. 2. Clutch switch wiring blank plug for auto's (see below). 3. Master cylinder switch - pull the plug, short with wire, go for a drive. Electrically, using Greg's manual, pull the cruise servo plug - you can continuity check everything in the system bar the servo itself if you have a decent cct diagram to follow, without pulling things apart, get someone to operate brake pedal and steering wheel switches. This will also check if the clutch switch wiring is shorted properly with the auto plug as well. where is this Clutch switch wiring blank plug for auto's located so i can check it?
_________________ 360 CL Lebaron
|
|||
| Top | |
|||
| snap0964 |
|
|||
|
KeeddleZ wrote: where is this Clutch switch wiring blank plug for auto's located so i can check it? Look in the jumble of wiring in front of and above the brake pedal - two wires, green/red & green/white going into a shorting plug. IIRC the cruise doco has a pic.
This is the EF/EL setup though.
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| South |
|
|||
|
Its the brake switch... no doubt about it
_________________ Fulli Sik Re |
|||
| Top | |
|||
| fourL6 |
|
|||
|
i think mine might just be the switches because the (-) button just started working yesterday(hold down ON and (-) and the horn should go) but the (+) isnt working and you cant check the resume button if (+) isn't working so i'll just try diff switches
_________________ Was - 2001 AUIII Ford Falcon Forte |
|||
| Top | |
|||
| Rick_Deckard |
|
|||
|
My on and off buttons work, but I don't think the other side of buttons are. Best course of action?
_________________ E39 523i |
|||
| Top | |
|||
| fourL6 |
|
|||
|
check if its just the plus hold down the on and (-) and if the horn doesnt beep then its probly the right side if the horn does beep then it might just be the Acc button
_________________ Was - 2001 AUIII Ford Falcon Forte |
|||
| Top | |
|||
| Rick_Deckard |
|
|||
|
Yeah horn doesn't sound, so I know (-) doesn't work, good chance the rest don't work either? (on that side).
Because I can get CRUISE to show up and leave on the cluster via ON and OFF buttons.
_________________ E39 523i |
|||
| Top | |
|||
| daniel229900 |
|
||
|
hey guys, im a noob at this lol, i have the same issue, cruise light working but cruise will not engage, how to i check the brake switch?
|
||
| Top | |
||
| daniel229900 |
|
||
|
my brake lights work, all my fuses seem to be ok, i pressed on and decel and the horn didnt sound ether..
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 92 guests |
