|
| FordAUte |
|
||
|
First of all I'll state the the vehicle is my cousins's VY SS ute...
Juat got a new centre bearing in the tail shaft, and upon picking it up from 'mechanic A' he said it required a tail shaft alignment. So my cousin called 'mechanic b', asking how much a tail shaft alignment was going to set him back. 'Mechanic b's response was that 'mechanic a' f**k up and if that's required you may as well get new tailshafts... Vibration is smack on 40km/hr when being feed lightly/heavily. Also, but less consistently, when under power going around a tight corner... What the hell is going on? Any advice, or help would be appreciated.
_________________ "08 XR6T Ute |
||
| Top | |
||
| Shen Long |
|
|||
Age: 49 Posts: 391 Joined: 22nd Aug 2008 Ride: 2002 AUII Fairlane Sportsman V8 Location: Roxby Downs |
which way is the car turning around a corner (left or right) when the vibration occurs???
|
|||
| Top | |
|||
| FordAUte |
|
||
|
Umm... Would have to go for another drive to be sure, but I think left.
_________________ "08 XR6T Ute |
||
| Top | |
||
| 67RCE |
|
||
|
Have a look at diff mounts and cradle....
_________________ ILL60 - EF XR8, Sunroof, Ticky Kit, 19x8.5/19x11 TE37's, 347, AFr185's, TFS BoxRcustom converter, Hurst Quarterstick, huge billet cam. |
||
| Top | |
||
| FordAUte |
|
||
|
Will it be an obvious visual thing?
I'll get under it tomorrow in the light and have a good look.
_________________ "08 XR6T Ute |
||
| Top | |
||
| Chargd |
|
|||
|
ok, i had an issue similar to this with my old vt xu6, but it did it all the time at certain speed. Turned out my tailshaft was out of balance and worn bushs. Made sense in my situation because i used to do alot of burnouts and treat it like s**t, no im not bragging about it just stating that it was abused. I'd be checking bush's first and in an extreme circumstance consider getting tailshaft balanced.
Obviously this is an extreme case, check everything is tight and looks proper before going to this measure.
_________________ 95 Ef Gli, mods : Tickford Head, Tickford ecu, Pacemaker 4499, Venom 100 cpi cat, Redback 2.5" catback, Wade 977b cam, ba xr6 intake and SS inductions, k & n filter & leather seats. 147.5kw @ wheels |
|||
| Top | |
|||
| 61xkwagon |
|
||
|
tailshaft bolts done up properly? i know it sounds stupid but i have seen it at work haha
_________________ i hate it when its raining, makes my left foot slip off the clutch all the time |
||
| Top | |
||
| FordAUte |
|
||
|
Now that I'm finally awake, I'll head out and have a look at this tail shaft setup. See what I can find.
_________________ "08 XR6T Ute |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 75 guests |
