Can anyone help with the airbag diagnostic codes and how to clear them on an AUII ute..

Cheers

its for e series bat should help....
{DESCRIPTION}

right down the bottom is how to clear and read airbag codes...

Thanks but it is an 11/01 auII ute and the diagnostic connector is totally different.

It has more like an obd2 connector in it.

I have the codes 19 & 46 but i just need to clear them so I can retest as it has had a new airbag fitted.

Cheers

i have a 2000 AU series 2 ute and i had the same problem, it turned out to be the passenger side airbag. but my ute didn't have a passenger airbag it has a resistor instead and the resistor needed to be replaced. the resistor in my ute was located on the back of the airbag panel and after changing it i haven't had any trouble, but it is pretty hard to get too i broke the panel out and fixed the panel after changing the resistor. to tell if you have a passenger airbag it should have SRS stamped or written on the panel and if it does then you have both airbags.

but id check with a mechanic to be safe

Thanks

Does anyone know if you can actually clear or resetthe codes without a scan tool?

old thread...yes i know.

Where is the resistor located????

OK, never mind - i've worked it out

{DESCRIPTION}