|
| ef_falcon_95 |
|
|||
|
I have ba/Bf injectors in my el , problem is since they don't have the groove for the clips they can float in and out of the rail , one was so far out I could see the o ring . I pushed them back in . Has anyone overcome this issue ??
Will a au fuel rail work ?
_________________ El XR6 Turbo |
|||
| Top | |
|||
| Esteven8 |
|
|||
|
{USERNAME} wrote: Will a au fuel rail work ? As far as I can tell the AU (AU1 anyway) rail where it concerns injector fitment is identical to the EF/L series ones. The only difference between them is how the fuel pressure regulator is attached to the rail. So from that I don't see any gain in using the AU rail to solve your issue.
_________________ {USERNAME} wrote: Cheap pads squeal like cheap hookers, and you can take that to the bank. {DESCRIPTION} {DESCRIPTION} |
|||
| Top | |
|||
| TROYMAN |
|
||
|
the ba injectors should have the groove, i had them when i was supercharged..
i did change to au rail later on and the injector placement is the same... |
||
| Top | |
||
| ef_falcon_95 |
|
|||
|
I'll find the clips and see if I can get them to fit . There is one groove but it doesn't go around the whole injector only half of it .
_________________ El XR6 Turbo |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 24 guests |
