|
| deandean |
|
||
|
if anyone can help that would be great!
|
||
| Top | |
||
| Johnson stroker |
|
|||
|
what is the offset and stud pattern, then I will tell you.
_________________
|
|||
| Top | |
|||
| FordAUte |
|
||
|
Yes, I have a mate that's about to fit a set to his BA ute...
Though the centers won't clear the hub, my mate had to come to me at work and get the centers milled out but a few mm. Could be done without a mill. But I had access to one, so it was easier (though I had to pay $180 for the convenience).
_________________ "08 XR6T Ute |
||
| Top | |
||
| Matt_jew |
|
||
|
Way too many variables there.
If they are off something like a series 1 RX they will be 4 stud so the answer is defiante no. If they are off a later one possibly , maybe , dunno , probably not...........................................
_________________ {USERNAME} wrote: More people paid for a ride in a VT commodore then an AU Falcon so the VT is superior.
Based on that fact my Mum is the best around! |
||
| Top | |
||
| FordAUte |
|
||
|
Cant find a picture of the wheels my mate has, but they are 18" thin-ish 5 spokes with dimple like holes in each spoke (can't remember if there are one or two dimples per spoke). Sound about right?
_________________ "08 XR6T Ute |
||
| Top | |
||
| FordAUte |
|
||
|
 This is the one...
_________________ "08 XR6T Ute |
||
| Top | |
||
| krisisdog |
|
|||
|
Centre bore is too small as mentioned.
Offset and stud pattern is correct. Wont fit straight up. |
|||
| Top | |
|||
| deandean |
|
||
|
thanks guys, ill try and put one on my car before i buy it
|
||
| Top | |
||
| low_ryda |
|
|||
|
it's a centre locating rim it does need machinery to bore it out, the die grinder won't cut it. could be done on a lathe if big enough, vertical borer would be the best bet. carton of ale or two at the right machine shop might see you through.
I must add also that with these gray area jobs your liability can escalate in the worst case scenario having parts like these fitted to your car. In the case of an accident insurers may refuse claims etc.
_________________ Not to get technical, but according to chemistry alcohol is a solution. |
|||
| Top | |
|||
| FordAUte |
|
||
|
Lucky we didn't take to it with a due grinder then... Lol
Umm wouldn't recommend a lathe, horrible run out... Would be a nightmare. Either Cnc mill, or vertical borer would be the go... And like low_ryda made comment on, a carton goes a LONG way!  +1 to the liability thing too... Not only for your car, but some workshops won't do it for riak of being sued. My boss nearly said no... :/
_________________ "08 XR6T Ute |
||
| Top | |
||
| ReGiE |
|
|||
|
they are also RX8 wheels
_________________ Gooooone - Eb2 Coon - 143RWKW |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 53 guests |
