|
| the_scotsman |
|
|||
|
Im currently in the process of installing driving lights to my EL XR6.
I cannot for the life of me find a hole in the firewall that I can run a wire through for the switch. Does anyone know where I can find one? Cheers |
|||
| Top | |
|||
| madeaspack |
|
||
|
if its an auto there will be a hole where the clutch cable would bo through otherwise pull out a grommet and feed your wires through it!
_________________ 97 el xr6,5 speed short shifter,sequential scoop,no arial,freshly resprayed,low on 17's,3 inch zorst,stainless hi flo cat,snort stage 3 stainless manifold,garrett t04e,front mount cooler,wolf 3d ecu,seimens 760cc injectors,walbro fuel pump |
||
| Top | |
||
| twr7cx |
|
|||
|
{USERNAME} wrote: if its an auto there will be a hole where the clutch cable would bo through
First thing I thought of too, but if you read his signature, his cars a manual. |
|||
| Top | |
|||
| FTR-XR6 |
|
|||
|
Isn't there a plugged opening just to the right of the master cylinder? I'm sure thats where I ran my line for my battery for the stereo.
_________________
|
|||
| Top | |
|||
| newbi EL |
|
||
|
{USERNAME} wrote: Isn't there a plugged opening just to the right of the master cylinder? I'm sure thats where I ran my line for my battery for the stereo. That is the 1 . I used tht 1 for my amp power cable.It,s the only 1 I could find aswell. I think there is 1 on the left as well ( where the bonnet cable goes ) but that looks to hard to get into.
|
||
| Top | |
||
| the_scotsman |
|
|||
|
Thanks, I'll check them out tomorrow night...
Just finished fitting the lights tonight...what a f**k around that was... Had to make up some custom brackets to mount the lights to...there is NOWHERE near the hole to fit the light to...all is sweet now though. |
|||
| Top | |
|||
| xr Rob |
|
|||
|
yeah i ran mine through the hole where the bonnet cable through and that was a 4 gauge power cable so u should be able to fit a few little wires through
_________________ If you think life is bad. Imagine being a egg...you only get laid once, you only get smashed once and the only bird that sits on your face is your mum! |
|||
| Top | |
|||
| Punnisher_42 |
|
|||
|
find a likely spot where your not going to hit anything, and make your own.
_________________ Regards, |
|||
| Top | |
|||
| voids |
|
|||
|
drill your own and use a small cable gland or grommet.
_________________ '96 DF II LTD 6cy |
|||
| Top | |
|||
| mickysacca |
|
|||
|
i also ran mine thru the bonnet release cable grommit, but whilst feeding the 4 guage wire thru, the bloody thing slipped out. crawlled under the dash and was near impossible to pout some force on it to shove it back in... in the end i split the grommit, cut out some material in the middle and replaced it. then just went round it with some silicon. should be sweet now
|
|||
| Top | |
|||
| voxace |
|
|||
|
Yeah there's actually a few places.
Another one is the accelerator cable hole. |
|||
| Top | |
|||
| the_scotsman |
|
|||
|
DONE!!!!
I ended up using the accelerator cable hole, was easy to access and had plenty room.... Im very pleased with the results!! {DESCRIPTION} {DESCRIPTION} {DESCRIPTION} {DESCRIPTION} {DESCRIPTION} I still need to tidy up the wires a bit. And the light shines under the car at the front, almost looks like white neons or something LOL, I'll need to try and block that off a bit. I might try hacking up the vent cover that I removed, to block up the hole on the outside of each light, make it look a bit more snug....but I'm quite pleased with the result! |
|||
| Top | |
|||
| Mechan1k |
|
||
|
Looks neat ... very nice work
_________________ 04 Territory TX AWD - Winter White - optioned up |
||
| Top | |
||
| Punnisher_42 |
|
|||
|
i agree, that looks absolutely awesome scotsman
_________________ Regards, |
|||
| Top | |
|||
| snap0964 |
|
|||
|
Yep great job, Have to keep an eye out for it in the traffic . . .
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 29 guests |
