|
| Smithysix |
|
|||
|
I’m sure this has been covered before and before the flaming, I have searched for this to no avail.
Is there a problem swapping an AU S3 motor with another AU falcon motor (Unknown Series, Rebuilt) In terms of smart shield noticing the difference? If so what is used to identify the change in motor and can it be swapped from one motor to the other? I intend on swapping over everything including the BBM. Thank you.
_________________ Series 3 AU Falcon : Shift Kit, Herrod Motorsport 4499's, 100cpi Cat, Lukey 2.5 Catback,Ebiach Pro Kit, Monroe GT Short Struts, Usual P-plater crap,Alpine CDA-9856, Kicker speakers all round, Rear Speakers powered by a Kicker DX125 and SoundStream T5-12 powered by a Soundstream TX 1300.D |
|||
| Top | |
|||
| galapogos01 |
|
|||
Posts: 1139 Joined: 27th Feb 2005 Ride: Supercharged EF Fairmont Location: T.I. Performance HQ |
If you swap the engine and leave all electronics alone you will be fine.
The only issue would be in fitting an S1 engine with the earlier map sensor. Fitting your old engines map sensor and BBM upper would resolve this.
_________________ {DESCRIPTION} - {DESCRIPTION}, {DESCRIPTION}, {DESCRIPTION}, {DESCRIPTION} and more! |
|||
| Top | |
|||
| Gab1 |
|
|||
|
{USERNAME} wrote: If you swap the engine and leave all electronics alone you will be fine. The only issue would be in fitting an S1 engine with the earlier map sensor. Fitting your old engines map sensor and BBM upper would resolve this. Agreed, but just curious, why would you need to swap the upper BBM? Do they differ? I thought all AU BBM's were the same. Gab |
|||
| Top | |
|||
| TROYMAN |
|
||
|
{USERNAME} wrote: {USERNAME} wrote: If you swap the engine and leave all electronics alone you will be fine. The only issue would be in fitting an S1 engine with the earlier map sensor. Fitting your old engines map sensor and BBM upper would resolve this. Agreed, but just curious, why would you need to swap the upper BBM? Do they differ? I thought all AU BBM's were the same. Gab smartshield has nothing to do with what engine is in it, just double check that everything is connected and plugged in... the upper bbm is different from series 1 to series2/3 due to the way the map sensor is mounted... but, it donr matter as the series 1 and series 2 map sensors work in each other as they are both voltage based.. i have a series2 bbm and map sensor in my au1 and its fine.. |
||
| Top | |
||
| Smithysix |
|
|||
|
Thank you all for the helpful responses.
_________________ Series 3 AU Falcon : Shift Kit, Herrod Motorsport 4499's, 100cpi Cat, Lukey 2.5 Catback,Ebiach Pro Kit, Monroe GT Short Struts, Usual P-plater crap,Alpine CDA-9856, Kicker speakers all round, Rear Speakers powered by a Kicker DX125 and SoundStream T5-12 powered by a Soundstream TX 1300.D |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 18 guests |
