|
| TROYMAN |
|
||
|
87SIlude wrote: Yea don't usually see many aus with intake problems *(becides the gasket) My TB was filthy so had to clean something. Did you get any white smoke? thats because au's have there rockercover breather about 4" before the throttle body not directly into the throttle body like e series, |
||
| Top | |
||
| mreb |
|
|||
|
I tried nulon intake foam made a big difference ,i had troubles with the idle between gas and petrol for a while after using it the idle went from a staggered 300-400 rpm to 1100rpm on gas and after adjusting idle its the smoothest its been in years and idling at 650 rpm on gas even throttle response is great now ,with engine off sprayed some in the TB ,half can down pcv pipe and the rest in the cylinders wait 5 min and start it ,blew a bit of smoke ,
|
|||
| Top | |
|||
| 87SIlude |
|
||
|
I had seen that nulon one. Looks good havnt used it.
On that note had a liberty in today, never had the upper cylinder treatment done. HOLY GERMAN SHIZA! Filled the workshop. Took 2 cans and my god was like a new car. Owner was over the moon. |
||
| Top | |
||
| 79 raven |
|
|||
|
Ill second the Nulon stuff, works a well. Also to the bloke using the brake fluid, while it works well on the old carbies, its not the best to use on injected cars. Wouldnt touch that stp crap or the Whynns stuff in the injector cleaner lines, waste of cash and its crap. Once again use the Nulon injector cleaner or total fuel system cleaner, its cheap and works a treat.
|
|||
| Top | |
|||
| mreb |
|
|||
|
was thinking to get another can of nulon foam and give it a good clean now i know what im doing with it ,first can made a huge difference .im normally sceptical on this sorte of stuff and im surprised at how well this stuff works.
|
|||
| Top | |
|||
| ja_50_nh |
|
||
|
Can you buy the stuff from supercheap or repco?
Also i know where the thottle body is but where do you spray it into? Cheers. |
||
| Top | |
||
| mreb |
|
|||
|
got it from autobahn .dont know about the others.
|
|||
| Top | |
|||
| 87SIlude |
|
||
|
You remove the intake pipeing and spray it into the throttle body...
|
||
| Top | |
||
| Nathanhrv |
|
||
|
very very noob question i no but what does the throttle body look like and where is it on an EL? lol
|
||
| Top | |
||
| Greenmachine |
|
||
|
Is all this expensive off the shelf stuff as good as just sprayin hydraulic oil down the intake??
 (only older guys will probably get that one)
_________________ Sold the Greenmachine - now driving 2015 Jeep Cherokee Trailhawk. |
||
| Top | |
||
| EFFUTURA4.05SP |
|
|||
|
As a Manager at Super Cheap I can say we now stock the Nulon Upper Engine Foam. Bout $10.00
_________________ 1996 EF Futura factory manual |
|||
| Top | |
|||
| Shen Long |
|
|||
Age: 49 Posts: 391 Joined: 22nd Aug 2008 Ride: 2002 AUII Fairlane Sportsman V8 Location: Roxby Downs |
i bought the s**t cheapest throttle body cleaner from supercheap.
Done the best job out... 1) Remove Intake pipes etc 2) start car & let it warm up for a few minutes 3) get someone to keep car revs at around 3500 - 4000 RPM 4) spray the hell out of the throttle body (up & down left & right) 5) keep spraying even though it sounds like it will stall 6) after around 1/2 to 3/4 of a can your inlet & TB should be like new again. 7) use some cleaner in your ISC as well. |
|||
| Top | |
|||
| winman |
|
|||
|
i followed the instructions on my carby & TB cleaner can, clean engine cold, then start, then spray more, all it did was flood the engine and stalled the car
 . gonna try round two this weekend with someone pressing the accelerator pedal while i spray, damn i miss good old fly-by-cable. stupid electronic throttle is s**t and never should have been invented.
_________________ BA XR6 |
|||
| Top | |
|||
| winman |
|
|||
|
got someone to rev the car as i was spraying the cleaner in, the manifold looks as if its never been used before!!!! i can see raw metal!!! not just black
_________________ BA XR6 |
|||
| Top | |
|||
| CeeJaJay |
|
||
|
Heyy Guys,
Sorry to bring this back up, Im new to working on my Ford ef and i just got some of that Nulon intake cleaning stuff and it says to spray it in a Vacuum hose. If any one has the can its number 2 on the back of it and as i said im new and i dont know which vacuum line it is or were its located. Help please Cheers Chris |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: Google Adsense [Bot] and 94 guests |
