|
| 00auford |
|
||
|
Theres a miss when put the cruise control on, the car is fully tune thx....
Whats the way of checking the cruise control diagnostics for correct operation ? Cheers. |
||
| Top | |
||
| 93EB |
|
|||
Age: 47 Posts: 2486 Joined: 6th Oct 2005 Ride: 93EB Fairmont / BA Falcon XR6T Location: Western Sydney |
Title and thread question fixed up.
_________________ 93 EB II Fairmon8 with 17' EL GT's / Clear indicators / H.I.Ds / Sports exhaust / Lowered 2' / K&N / XR6 ECU. |
|||
| Top | |
|||
| TimmyA |
|
|||
|
Your post did say this:
{USERNAME} wrote: L - Check Vehicle Speed Sender Circuit Yes - Go to part M Measure the Resistance between Pins 3 and 10 IS THE RESISTANCE BETWEEN 800 AND 1100 OHMS ? No - Check Speed Sender and Circuit ive done some test on au II Cruise control module and ive come up with this ! and my resistance is 445 n its under 800 n 11000 ohms. so, where do i find the " check the speed sender ? thx... If what your wrote there when I opened the post was right then: Measure between pin 3 and the body? Same or similar result? Pin3 three comes from the instrument cluster... does the speedo work properly on the instrument cluster? if so that proves speed in... the white wire at the cruise module is from speed out on the cluster... What's it no doing? not setting but turning on? make sure that pin 9 has 12V present with key on? make sure that pin 4 has 12V present with foot on brake? make sure brake lamps are not blown? make sure led brake lamps are not fitted? make sure resistance between pin 5&6 is: 120ohms for set - 680ohms for set + 2200ohms for coast that's easier than changing a cluster out first... Cheers, Tim
_________________ {DESCRIPTION} |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 22 guests |
