|
| Disco Frank |
|
|||
|
so if you pull the rockers off ( in 1 piece )
to take the cam out and you forgot which way they go on can the exhaust go on the intake and vice versa? according to the book one of the rockers have a slight bend in them but the ones on this engine do not also the engine runs fine ( bar excessive fuel use ) and the rockers line up with the tops of the valves cheers!
_________________ RIP SCOTT |
|||
| Top | |
|||
| TROYMAN |
|
||
|
the whole assembly can only go on one way....
what cam did you fit??? au ecu's are fussy bastards adapting when it comes to cam changes.. |
||
| Top | |
||
| cjh |
|
|||
|
The front cam bridge can only go on 1 way, it has off-set bolt holes.
_________________ http://youtu.be/jJTh9F3Vgg0 |
|||
| Top | |
|||
| Johnson stroker |
|
|||
|
Frank will find a way to make a square peg go into a round hole and f**k it all in the process.
Your welcome,
_________________
|
|||
| Top | |
|||
| Disco Frank |
|
|||
|
Troyman wrote: the whole assembly can only go on one way.... what cam did you fit??? au ecu's are fussy bastards adapting when it comes to cam changes.. no cam, the cam came out so i could get the head fixed... mmm glad to know it can only go one way mmm next step injectors i guess
_________________ RIP SCOTT |
|||
| Top | |
|||
| Pakrat |
|
||
|
What was wrong with the head? Was the head removed?
I would be checking the cam timing first. Then I would be checking for any vacuum leaks, at the inlet manifold (was the gasket replaced if removed?), vacuum lines, PVC hoses, map sensor hose and make sure everything is hooked up, o2 sensor ect. Injectors are unlikely to make a car run that rich all of a sudden. |
||
| Top | |
||
| Disco Frank |
|
|||
|
Pakrat wrote: What was wrong with the head? Was the head removed? I would be checking the cam timing first. Then I would be checking for any vacuum leaks, at the inlet manifold (was the gasket replaced if removed?), vacuum lines, PVC hoses, map sensor hose and make sure everything is hooked up, o2 sensor ect. Injectors are unlikely to make a car run that rich all of a sudden. welsch plug under cam corroded = head off job ( car was bought this way ) cam timing is spot on the car fired up on 1st turn as in 1 sec or under of cranking then again it COULD be out... au i6 no map sensor its a TMAP  o2 sensor new, same as plugs/leadsl/fuel filter ill start another thread
_________________ RIP SCOTT |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: NONE-YA and 59 guests |
