|
| sexyr6 |
|
|||
|
This is on a customers car, the car came to me not running (engine done a bottom end) so I fitted another engine in it, and have this issue where when you push the throttle in about half way the engine cuts out, but before it completely stalls I can remove my foot and it continues to run, I have replaced the TPS with no change. any ideas guys? cheers.
_________________
Last edited by sexyr6 on Sat Aug 17, 2013 6:34 pm, edited 1 time in total. |
|||
| Top | |
|||
| 96ELGli |
|
||
|
Hi,
Have you checked fuel pressure ?
_________________ Regards 96ELGli |
||
| Top | |
||
| sexyr6 |
|
|||
|
I haven't yet no, I'll check that out.
_________________
|
|||
| Top | |
|||
| sexyr6 |
|
|||
|
not sure if that sounds like the issue tho, as the engine cut's out like it looses spark and fuel..
_________________
|
|||
| Top | |
|||
| sexyr6 |
|
|||
|
I got the car back to try and sort this issue out, I discovered that the motor I fitted to it had different sensors on it than the original engine, the car itself is a series II and the motor I fitted to it was a series one engine, I have swapped over the upper part of the intake and the engine loom from the old engine, now the original issue I was having with it is gone, but now it is running extremely rich to the point it will not idle, I have disconnected the battery to reset the ECU, but I have a feeling that this will not solve the issue, any ideas on what could be causing it?
_________________
|
|||
| Top | |
|||
| macca2042 |
|
||
|
What sensors were different?
|
||
| Top | |
||
| Mad2 |
|
|||
|
macca2042 wrote: What sensors were different? intake |
|||
| Top | |
|||
| sexyr6 |
|
|||
|
all sorted now, had a collapsed catalytic converter..
_________________
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 79 guests |
