|
| xELFalconx |
|
|||
|
Changed relays, installed fans that I know work, checked all fuses, etc. Can't get them to work. They kick in at high speed for a few seconds until the car cools down and then stop. They can be turned on with a scan tool, but only the passengers side comes on. Both fans worked perfectly before I pulled them from my old EL.
Any ideas?
_________________ 4.0L Tickford six, 1645b E-series custom grind, MLS gasket, performance valve springs, 3" stainless intake, extractors, 2.5" Lukey, 100cpi hi-flow, T5 manual, J3 tune. |
|||
| Top | |
|||
| Falcon96XR6 |
|
|||
|
Ecu or wireing fault.. is all it can be..
If youve replaced all fuses, relays etc,
_________________ EL XR6, T5 Speed - Full Factory Fitted Tickford Body Kit, AU Engine, Billet Camtech 845 Cam, J3 Chip, MLS Gasket, Intake, Extractors, High flow cat, 2 1/2in exhaust, K&N Air Filter, 3.45 LSD, - My Pride and Joy |
|||
| Top | |
|||
| xELFalconx |
|
|||
|
That's what I was afraid of. Any idea on the simplest way to fix this, or should I just pull out the loom from my EL and hope for the best?
_________________ 4.0L Tickford six, 1645b E-series custom grind, MLS gasket, performance valve springs, 3" stainless intake, extractors, 2.5" Lukey, 100cpi hi-flow, T5 manual, J3 tune. |
|||
| Top | |
|||
| TedW |
|
||
|
fix the problem you have rather than introducing new faults - wiring diagrams and trace circuits first - are relays correct ones as there are 2 different types used ?(normal and change over)
|
||
| Top | |
||
| 96ELGli |
|
||
|
Hello,
It will be far easier to fix the problem you have. Have a look at the Tech Docs, and you can force the Fans to either Hi or Low for testing. One relay is the change-over relay, it uses an extra pin and is a different colour.
_________________ Regards 96ELGli |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: Google [Bot] and 44 guests |
