Fordmods Logo

AU2 dies under acceleration 

 

Page 1 of 1 [ 6 posts ] 

 
 Post subject: AU2 dies under acceleration
Posted: Sat Aug 25, 2012 4:33 pm 
Fordmods Newbie
Offline

Age: 51

Posts: 2

Joined: 25th Aug 2012

Ride: Ford AU2 SR

Location: coffs harbour
NSW, Australia

I bought a 01 Au2 a week ago , when i take off if i press the pedal to fast the engine will die , take my foot off it starts again , it doesnt do it in park or neutral , it revs out fine then , when i drive normally it fine and i can get it to the speed limit ( 110 ) , it sounds like a dry bearing in the fan belt area aswell ( like an ungreased pully sound ) , anyone had this problem , thought it might be the fuel pump , but i can flatten it and it wont die in park
Top
 Profile  
 
 
 Post subject: Re: AU2 dies under acceleration
Posted: Mon Aug 27, 2012 12:24 pm 
Getting Side Ways
Offline

Posts: 890

Joined: 1st Apr 2005

Gallery: 4 images

Ride: EF XR6 Wagon, AU2 XR6 VCT

Power: 148 rwkw

Location: Auckland
New Zealand

The dry bearing sound could very well be just that. There are two idler pulleys (one ribbed, one flat) that are "lubed for life" but do ultimately fail. They are cheap and easy to replace.

The engine dying does sound like fuel starvation. Can I ask a silly question? How much fuel is in the tank when it does this? If the fuel is very low, hard acceleration can slosh the fuel to the back of the tank, so the fuel pump is sucking air. Of course it would be fine when stationary in N or P.

If it doesn't do it even a little when you snap the throttle open fast in neutral, it can't be a vacuum problem, as it would experience a similar instantaneous vacuum drop in neutral as it does in gear.

 

_________________

95 EF XR6 wagon, 17" FTRs, DBA rotors, KYB/Koni, AU bottom end, ported EF head, backcut valves, SS Inductions, Territory intake, 10.2 CR, Auckland 1258 cam, vernier gear, PH4480 headers, no cat, Tickford 2.5", 2800rpm stall, J3 chip

Top
 Profile  
 
 
 Post subject: Re: AU2 dies under acceleration
Posted: Mon Aug 27, 2012 12:36 pm 
Getting Side Ways
Offline
User avatar

Age: 46

Posts: 841

Joined: 20th Feb 2010

Gallery: 2 images

Ride: AU Fairmont Ghia

Location: Elizibif Norf (Local Spelling!!)
SA, Australia

I'd also check the leads, plugs and coil-pack as well. My EF had a similar issue ages ago, felt almost like the trans slipping. Only did it under load and within a certain rev range (Can't remember exactly what it was... 2 - 2,500 rpm or thereabouts), it turned out to be dodgy ignition leads. Swapped them out, new coil-pack and platinum plugs as well, never had an problem since.

 

_________________

{USERNAME} wrote:
Cheap pads squeal like cheap hookers, and you can take that to the bank.


{DESCRIPTION}
{DESCRIPTION}

Top
 Profile  
 
 
 Post subject: Re: AU2 dies under acceleration
Posted: Mon Aug 27, 2012 3:13 pm 
Fordmods Newbie
Offline

Age: 51

Posts: 2

Joined: 25th Aug 2012

Ride: Ford AU2 SR

Location: coffs harbour
NSW, Australia

Thanks for the answers

it does it if the tanks is full or empty ( doesnt like hill starting on empty )

as of yesterday ( sunday ) it has developed a rough start - it wont start first try second it splutters abit , not that bad but i notice it , but starts

i have an old ED here , i gather the fuel pump is different , but ive had the leads replaced so ill use them

it has to be a fuel supply problem , when the engine dies i dont lose electrics , no warning lights come on , someone mentioned the throttle body sensor but why would it restart when i take my foot off ( it restarts like nothing had even happened )

im going to replace the pump , leads and spark plugs , see if it helps
Top
 Profile  
 
 
 Post subject: Re: AU2 dies under acceleration
Posted: Mon Aug 27, 2012 3:28 pm 
Technical Contributor
Offline

Age: 67

Posts: 6815

Joined: 22nd Jun 2005

Gallery: 8 images

Ride: EF Fairmont

Location: Campbelltown
NSW, Australia

ED leads won't fit a coil pack. AUII/III are different again from the EF/AUI leads as well. Check your fuel filter as well.
Top
 Profile  
 
 
 Post subject: Re: AU2 dies under acceleration
Posted: Thu May 22, 2014 7:45 pm 
Fordmods Newbie
Offline

Age: 54

Posts: 4

Joined: 27th Feb 2012

Ride: ford xr6

Location: perth
WA, Australia

Having same/similar problem.
The car starts but cannot take much acceleration maybe 5 - 10mm on pedal, any more and it pops/dies as if it's out of fuel. The effect is not as bad when I'm moving but starting from the lights is gonna get me abused. 20 - 30 meters at 10 - 15kph. I put a new fuel filter on & no difference.
Anyone find out the exact cause?

 

_________________

series II Au Xr6
All tickford options except the bloody brakes.

Top
 Profile  
 
Display posts from previous:
Sort by  
 Page 1 of 1  [ 6 posts ] 

Who is online

Users browsing this forum: No registered users and 24 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

 

 

It is currently Mon Dec 23, 2024 1:29 am All times are UTC + 11 hours

 

 

(c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names