|
scotty69u |
|
||
|
my car starts fine but when driving it wont kick into overdrive (gets to 50 to 60km/h and then need to give it a boot full to make it go) and also sometimes it stalls when placed from reverse into drive its a 1998 el ford fairmont ghia with auto transmission any advice on what the problem could be
|
||
Top | |
SWC |
|
||
|
scotty69u wrote: my car starts fine but when driving it wont kick into overdrive (gets to 50 to 60km/h and then need to give it a boot full to make it go) and also sometimes it stalls when placed from reverse into drive its a 1998 el ford fairmont ghia with auto transmission any advice on what the problem could be Do you mean that it won't change up gears? or just has no go after 50 to 60kph? |
||
Top | |
scotty69u |
|
||
|
SWC wrote: scotty69u wrote: my car starts fine but when driving it wont kick into overdrive (gets to 50 to 60km/h and then need to give it a boot full to make it go) and also sometimes it stalls when placed from reverse into drive its a 1998 el ford fairmont ghia with auto transmission any advice on what the problem could be Do you mean that it won't change up gears? or just has no go after 50 to 60kph? it is as if it has no get up and go unless you put your foot down hard on the gas |
||
Top | |
SWC |
|
||
|
Is it blowing any smoke, blue, white etc?
|
||
Top | |
SWC |
|
||
|
Have you checked the the usual things, plugs, leads, fuel filter, fuel pump?
How is the timing? Condition of the Dizzy/Cap/Rotor Button? MAP Sensor? O2 Sensor? Collapsed Cat? |
||
Top | |
scotty69u |
|
||
|
checked all plugs and leads timing is fine might have to check the senors and its as if its not kicking into overdrive were do i find all them senors as i said im hopeless lol
|
||
Top | |
scotty69u |
|
||
|
SWC wrote: Is it blowing any smoke, blue, white etc? no it doesnt blow smoke just doesnt kick into overdrive i think and then this morning it stalled when shifting from reverse into drive |
||
Top | |
SWC |
|
||
|
How long have you had the car?
|
||
Top | |
scotty69u |
|
||
|
SWC wrote: How long have you had the car? i've owned it for just over 2years |
||
Top | |
scotty69u |
|
||
|
JUST READ THIS COULD BE THE PROBLEM I THINK as i only had the transmission service done mid september were can i find the TPS and stuff
if the throttle position sensor (TPS) fails, the transmission will shift erratically & may not shift to overdrive (torque converter will not lock) if a solenoid or temp sensor fails the transmission wont function correctly & may result in the ecu switching to "limp mode" ie: stays in 3rd gear.....you can purchase service kits from Burson Auto Parts for around $20 NOTE: (1) selector shaft seal part #P6042...requires 2 seals, 1 behind the selector actuator & 1 behind the inhibitor switch. NOTE: (2) there are two rear seal types available, boot & non boot, the easiest seal to fit with good results is part #P6231 non boot type for around $5 from repco or bearing & seal retailers. scotty69u wrote: SWC wrote: How long have you had the car? i've owned it for just over 2years |
||
Top | |
scotty69u |
|
||
|
scotty69u wrote: SWC wrote: How long have you had the car? i've owned it for just over 2years i just did a self check on my tps with a volt meter thing with engine on BUT not running as instructed on another site but i got no readings from any of the three prongs in it and the other site says it should read 5volts |
||
Top | |
scotty69u |
|
||
|
SWC wrote: Have you checked the the usual things, plugs, leads, fuel filter, fuel pump? How is the timing? Condition of the Dizzy/Cap/Rotor Button? MAP Sensor? O2 Sensor? Collapsed Cat? how do i check for callapsed cat? |
||
Top | |
TimmyA |
|
|||
|
Why don't you start by checking the PCM for codes?
There is info on how to check for codes in the tech docs in the top navi bar... If something electronic has failed the PCM will tell you what... If you get no codes then look for something mechanical... Cheers, Tim
_________________ 93 Red ED 5spd Manual Build Thread |
|||
Top | |
efxr6wagon |
|
||
|
Throttle position sensor is a main input to transmission shift control. If it is sending no signal, I can't imagine what the ECU is telling the transmission to do - probably some sort of limp mode.
_________________ 95 EF XR6 wagon, 17" FTRs, DBA rotors, KYB/Koni, AU bottom end, ported EF head, backcut valves, SS Inductions, Territory intake, 10.2 CR, Auckland 1258 cam, vernier gear, PH4480 headers, no cat, Tickford 2.5", 2800rpm stall, J3 chip |
||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 48 guests |