Last week I was trying to fit a single zone preminum icc in my xl ute but I just kept bending the pins at the back of the icc so I tryed to modify the plug but ended up doing major damage so I took it to ford to ask if they could fix it but they needed 1400 to fix it because they said I need a new dash loom 6hrs removing the dash and a $500 new dash loom so instead of paying that much can I please have some advice on how to remove a dash

I want to go to the wreckers and pull a dash out on a car there before I do it to my own car

Car still drives but I have no guages or icc working apart from the fuel gauge

Advice and tips please and thankyou

got a link to the mixer shaft replacement in the document it goes through removing the dash also its on the ford forums site
http://www.fordforums.com.au/vbportal/v ... cleid=1290

not sure if it mentioned in the document for removeal but dont forget the connector on the airbag module mounted on the trans tunnel around the icc

hope this helps