|
| Falcon96XR6 |
|
|||
|
Hey all, simple question I can't find an answer to...
Can I set the base timing with the j3 plugged in? Or does it have to be removed? If it does not have to be removed, it will still do the usual 2 mins then drop in revs etc? Thanks all, Tait
_________________ EL XR6, T5 Speed - Full Factory Fitted Tickford Body Kit, AU Engine, Billet Camtech 845 Cam, J3 Chip, MLS Gasket, Intake, Extractors, High flow cat, 2 1/2in exhaust, K&N Air Filter, 3.45 LSD, - My Pride and Joy |
|||
| Top | |
|||
| creeture3 |
|
||
|
Might be an idea to contact T I Perfomance about this
|
||
| Top | |
||
| SMK |
|
||
|
creeture3 wrote: Might be an idea to contact T I Perfomance about this and Ti Performance replied that their chip doesnt effect ANYTHING, yeah right  i take it with irony and joy hahaha
|
||
| Top | |
||
| Mad2 |
|
|||
|
ummm ... how are you setting the base timing?
|
|||
| Top | |
|||
| EAfalconS |
|
|||
|
I was able the check the base timing with the J3 plugged in.. it behaved as normal.
_________________ EA falcon(S-Pac) AU engine and injector's, EL BBM conversion,K&N pod,EL ECU,T5 5speed,EL Streering rack, EL Brake system, Extractor's 2 1/2in high flow cat, through 2 1/2in mandrel bent pipe with Lukey Performance muffler |
|||
| Top | |
|||
| Mad2 |
|
|||
|
i'll rephrase that .... what did ya do so you could do the base timing?
|
|||
| Top | |
|||
| EAfalconS |
|
|||
|
I put mine in base time mode as normal.. Earthed the STO > engine speed raised then fell > idled> after a min or so idle fell into base mode..> checked timing tweaked it then shut the car off. All with the J3 installed.
_________________ EA falcon(S-Pac) AU engine and injector's, EL BBM conversion,K&N pod,EL ECU,T5 5speed,EL Streering rack, EL Brake system, Extractor's 2 1/2in high flow cat, through 2 1/2in mandrel bent pipe with Lukey Performance muffler |
|||
| Top | |
|||
| Nigel |
|
||
|
A J3 chip doesnt affect the DIAGNOSTIC functions at all. That is, unless you turn some of them off. Thats another conversation.
The other thing that might change is if you run an EL/XH ECU, in your EA/B/D, as the diagnostic procedure (and base timing mark) is different (if I recall correctly - but I never said that I do!) Diagnostic most should just work fine. |
||
| Top | |
||
| xafalcon |
|
||
|
The KOER diagnostic mode used to set base timing can only operate in neutral (and park in auto)
Is your neutral switch working correctly? If you have a manual conversion chip, is the neutral switch re-wired correctly? - The V8's connect NDS to different inputs for auto and manual, not sure if I6's are the same??
_________________ XA Faimont 351C, AU2 XR8 Manual 5.0, DA LTD 5.0, Mk1 Capri 5.0, 1995 Mustang 5.0, EF2 XR8 Manual, EF2 Fairmont Ghia 5.0, AU3 XR8 Auto, AU2 XR8 Auto, AU2 XR8 Manual Ute, TE Cortina 5.0 Manual, DU LTD 5.0 soon to be manual |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 11 guests |
