Hey to those in the know, I accidentally cut my converted & lengthened 2-bar MAP sensor wiring & I was just about ready to connect it up again.
But me being the MR Forgetful that I am I was just wondering if this is the correct way to do it?
Look at the masterpiece below & tell me if how I am connecting the standard wires to the 2-bar MAP sensor plug is correct.
Cheers

from memory yes..

when I turbod my au I fitted the ba turbo tmap and wired it back to front just like your drawing

Thanks mate, from memory I thought it was the correct way to do it, but I just wasn't 100% sure.
I will get out the soldering iron tomorrow & patch her back up & see how she runs.
Good as new I hope.