|
| jamie22_cole |
|
|||
|
hey guys just wondering can either the map sensor or the tps switch cause pinging when underload on an EL XR6?
pinging gets worst when the car is hot. |
|||
| Top | |
|||
| EAfalconS |
|
|||
|
Knock sensor or a lean condition. EDIT: Timing could be advanced out of the knock sensors range. Trying a tank of 95 or 98 could point you in the right direction too.
_________________ EA falcon(S-Pac) AU engine and injector's, EL BBM conversion,K&N pod,EL ECU,T5 5speed,EL Streering rack, EL Brake system, Extractor's 2 1/2in high flow cat, through 2 1/2in mandrel bent pipe with Lukey Performance muffler |
|||
| Top | |
|||
| jamie22_cole |
|
|||
|
sorry forgot to mention already running 98 fuel in it
|
|||
| Top | |
|||
| jamie22_cole |
|
|||
|
sorry forgot to mention already running 98 fuel in it
|
|||
| Top | |
|||
| SWC |
|
||
|
Is the car stock, are there any engine mods etc?
|
||
| Top | |
||
| jamie22_cole |
|
|||
|
It has AU bottom end with EL Tickford head, wade 1673 cam, au injectors and rail, standard au fuel regulator, au knock sensor everything else is from the el motor
|
|||
| Top | |
|||
| SWC |
|
||
|
1) Check timing.
2) Check Fuel Filter. 3) Check Fuel Reg. 4) How old is the fuel? |
||
| Top | |
||
| jamie22_cole |
|
|||
|
timing is good pretty much spot on the mark, fuel is good as I fill up each week with 98, fuel filter should be good as I change it not too long ago and fuel reg unsure about would there be much difference going from a 300kpa XR6 one to an au standard one?
|
|||
| Top | |
|||
| EAfalconS |
|
|||
|
About 30kpa difference. Go to a wrecker and get a 3bar from a xr6 and a 3.5bar from a VCT/XR6 and trial them.
_________________ EA falcon(S-Pac) AU engine and injector's, EL BBM conversion,K&N pod,EL ECU,T5 5speed,EL Streering rack, EL Brake system, Extractor's 2 1/2in high flow cat, through 2 1/2in mandrel bent pipe with Lukey Performance muffler |
|||
| Top | |
|||
| MAD |
|
|||
|
Any particular RPM that it pings?
|
|||
| Top | |
|||
| SWC |
|
||
|
jamie22_cole wrote: timing is good pretty much spot on the mark, fuel is good as I fill up each week with 98, fuel filter should be good as I change it not too long ago and fuel reg unsure about would there be much difference going from a 300kpa XR6 one to an au standard one? EAfalconS wrote: About 30kpa difference. Go to a wrecker and get a 3bar from a xr6 and a 3.5bar from a VCT/XR6 and trial them. What Fuel Rail are you running? To fit the AU VCT Reg you will need either an AU or BA/BF Fuel Rail. When did it start pinging? After fitting the 270kpa reg or was it fine untill the weather warmed up? |
||
| Top | |
||
| jamie22_cole |
|
|||
|
I think maybe after installing the au fuel rail. but it ping bad when it gets warm and 2300rpm to 3500rpm especially on a hot day and travelling up a hill if that helps?
|
|||
| Top | |
|||
| jamie22_cole |
|
|||
|
Any ideas why it pings when it's warm?
|
|||
| Top | |
|||
| EAfalconS |
|
|||
|
It's running lean, up the fuel pressure to a 3 or 3.5bar regulator. I had good results with the 3.5.
_________________ EA falcon(S-Pac) AU engine and injector's, EL BBM conversion,K&N pod,EL ECU,T5 5speed,EL Streering rack, EL Brake system, Extractor's 2 1/2in high flow cat, through 2 1/2in mandrel bent pipe with Lukey Performance muffler |
|||
| Top | |
|||
| jamie22_cole |
|
|||
|
ok thanks for the reply EAfalconS
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: Google Adsense [Bot] and 52 guests |
