So what the hell could cause my car to not hit rev limiter? Just recently did a AU ecu into a EB with AU motor as well.. runs and drives fine.. But for some reason it doesn't hit limiter? Wtf, will rev past 6k up too near valve bounce a couple of times but after then limiter comes in at 2500-3000 for some reason until I disconnect battery and re connect and will then either go to normal 5800 limiter or none at all... The ecu is a lpg one but has a pre-tuned J3 but I couldn't think that would cause my issues.

pull the j3 chip out and re test

Didn't have cam angle sensor connected, so got that plugged in.. out of fuel atm so can't find out if it is fixed or not...

But will pull J3 out and in if it is still doing it, hopefully that could possibly be an issue.. Have heard J3 port connection can be an issue some times

Cheers

Need the j3 in for smart lock so can't test with out sadly..

how did the car run without the cam sensor connected???
you are talking about the one above the harmonic balancer right?

I know when my cam angle sensor failed the car would not start