|
| Mad2 |
|
|||
|
what's the best way to refit the upper inlet manifold as i don't have a lot of room & gasket keeps moving
|
|||
| Top | |
|||
| TimmyA |
|
|||
|
spray the gasket with some copper gasket sealer to make it sticky...
I'd leave two bolts hanging out of the upper and hover it while starting them by hand before dropping it onto the lower part... Sure I've done this before with little to no issues... Cheers, Tim
_________________ 93 Red ED 5spd Manual Build Thread |
|||
| Top | |
|||
| Mad2 |
|
|||
|
TimmyA wrote: spray the gasket with some copper gasket sealer to make it sticky... I'd leave two bolts hanging out of the upper and hover it while starting them by hand before dropping it onto the lower part... Sure I've done this before with little to no issues... Cheers, Tim sounds good! ... my problem is the LPG injection setup that is around the inlet manifold  ended up removing throttle body, LPG injection mounting brackets [two mount one side & one on other] & manifold vacuum actuator. brother-inlaw was able to get it in afta that 
|
|||
| Top | |
|||
| TimmyA |
|
|||
|
Ahhhh...
Can't help with that... I stay as far away from LPG as I can get...
_________________ 93 Red ED 5spd Manual Build Thread |
|||
| Top | |
|||
| Mad2 |
|
|||
|
TimmyA wrote: Ahhhh... Can't help with that... I stay as far away from LPG as I can get... vapour is easier re room to work. bad experience from LPG? |
|||
| Top | |
|||
| TimmyA |
|
|||
|
Na... Just know nothing about it... Not interested in it... Like 98...
_________________ 93 Red ED 5spd Manual Build Thread |
|||
| Top | |
|||
| Mad2 |
|
|||
|
no probs .... good to see ya got the turbo prob ironed out
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 96 guests |
