Hey everyone I'm new to these forums and only had about a years fiddling with falcon 4 litres after a lot of research and time I decided to start building one as I'm still on my plates for 2 years so I figured until I can get an 8 these online 6s have as much torque anyway my goal is to drop in a ef falcon motor bit of work crow 2519 cam aftermarket valve springs and rollers roll master vernier cam gear I plan on having it run with the t5 from the xg as well as the log manifold nd dizzy as I want to do this as cheap as possible as so far it's cost 1200$ all up and the ute is rather clean last motor ran average though. I'm wondering if anyone out there has done this swap before or one similar and has any tips or anything should be prepared for putting it back together? Any help will be greatly appreciated thanks