|
phillgr54 |
|
||
|
Hi
Cannot see how to release the ignition lock barrel on a AUI. PLEASE ADVISE |
||
Top | |
Robert_au |
|
|||
|
{USERNAME} wrote: Hi Cannot see how to release the ignition lock barrel on a AUI. PLEASE ADVISE The entire thing electronics and all or just the barrel the key fits in? IF i had to guess and i am here, if just the barrel, ACC position and push in the little brass pin in the hole with a 3mm drill bit slips out then IF the entire thing electronics and all think form memory was 4 4 bolts on top of the column, the new one would then need to be matched to the BEM
_________________ Current Ride |
|||
Top | |
phillgr54 |
|
||
|
Thanks for the reply. I just would like to remove the barrel but cannot find the hole to push in the drill after turning to acc. There is no holes when i lie on the floor and look up.
Thanks Phill |
||
Top | |
Mad2 |
|
|||
|
{USERNAME} wrote: Thanks for the reply. I just would like to remove the barrel but cannot find the hole to push in the drill after turning to acc. There is no holes when i lie on the floor and look up. Thanks Phill take the steering column covers off. all i can remember is two screws from underneath to undo |
|||
Top | |
SWC |
|
||
|
Is it Smartlock or Smartshield?
|
||
Top | |
phillgr54 |
|
||
|
I dont think its smartlock as it is AUII. The covers are off the column and I cannot see a hole to shove a drill to release the barrel.
|
||
Top | |
SWC |
|
||
|
{USERNAME} wrote: I dont think its smartlock as it is AUII. The covers are off the column and I cannot see a hole to shove a drill to release the barrel. Your first post says that it is an AUI. {USERNAME} wrote: Hi
Cannot see how to release the ignition lock barrel on a AUI. PLEASE ADVISE |
||
Top | |
phillgr54 |
|
||
|
So sorry..
We are a Ford family. We have 4 Fords all AU's but all from different series. The one I need to replace the barrel on is an AUII. |
||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 38 guests |