Just a quick question for anyone who knows the answer...
Radio, HVAC, Traction Controls, Door locks, Dome Lights and Iffo (petrol, mileage left, etc) don't work on ICC unit. Instruments, wipers, horn, everything else works. If I replace the WHOLE ICC and use my present BEM, will everything work, or am I screwed????

I have used FORSCAN and run OnDemand Self tests with U1900 DTC error only.

Thanks!!!

Rod

icc needs programming to vin. of vehicle with scantool genuine or some aftermarket units.

Have you checked all fuses in interior fuse box.
Check reverse lights work.
Remove icc and refit after resetting connection at rear of icc by pulling connection plug towards you slightly until it clicks.

Verify model is a BF.....

Yes all is working. I do have another question, though..... If I have a replacement BEM and 2 original keys, can I program the original keys to the replacement BEM using Forscan???

not sure myself as to what is possible with "forscan" I think you need to purchase a limited liscence to enable you to program 2 keys to new or existing BEM you then need to relink BEM and ECU ie. (parameter reset)-
hopefully this question can be cleared up by some one who has previously used "forscan" for this purpose.

suggest you swap old BEM for replacement unit before attempting this to allow you to swap back to original if it doesn't work and then also carry out parameter reset as mentioned above.

what is problem with existing BEM?