|
| Mad2 |
|
|||
|
snap0964 wrote: :?: snap0964 wrote: That's the item. I'm in the same predicament - both my wagons need that seal done eventually. What I was going to do was make a mock up tank section to fit a pump to, use sikaflex (if it's fuel resistant)and make moulds - ensure you lightly oil/grease mating sections so everything comes apart. That's as far as my thinking takes me currently. that comment sounds like me ..... hence the  
|
|||
| Top | |
|||
| snap0964 |
|
|||
|
Can't really remove any of the tanks at the moment - cutting one up at wreckers for that section is risky too, any fuel vapour will go up with a bang.
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| Mad2 |
|
|||
|
snap0964 wrote: Can't really remove any of the tanks at the moment - cutting one up at wreckers for that section is risky too, any fuel vapour will go up with a bang. only "if" your using an oxy/plasma cutter or grinder.............. 
_________________ http://www.fordmods.com/the-garage-f53/another-box-project-t116037.html Last edited by Mad2 on Fri Nov 16, 2018 9:41 pm, edited 1 time in total. |
|||
| Top | |
|||
| snap0964 |
|
|||
|
What else would you be using
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 80 guests |
