|
| Vicky |
|
||
Age: 52 Posts: 9 Joined: 30th May 2017 Ride: Fords bmw toyota landy Location: Port pirie sa |
Taking motor and trans out of 1994 ef v8 5 litre fairmount and want to put it in a 1995 nf fairlane that had a 6 in it what to know how to over come the wire differents
|
||
| Top | |
||
| 1tuff |
|
||
|
If your not planning on putting a v8 back in the ef then take the whole engine loom and ecu wiring out of the ef and remove all the 6cyl wiring and ecu from the nf.
_________________ To many project's and not enough $$$ |
||
| Top | |
||
| Vicky |
|
||
Age: 52 Posts: 9 Joined: 30th May 2017 Ride: Fords bmw toyota landy Location: Port pirie sa |
No we are not putting anything back in the ef
|
||
| Top | |
||
| 1tuff |
|
||
|
Cool just use the loom from the ef then.
_________________ To many project's and not enough $$$ |
||
| Top | |
||
| Vicky |
|
||
Age: 52 Posts: 9 Joined: 30th May 2017 Ride: Fords bmw toyota landy Location: Port pirie sa |
Is there a easyer way was tld you can but a jump wire in some how
|
||
| Top | |
||
| 1tuff |
|
||
|
No, you are going to need two extra fuel injector loops to put into the system, then the way the wiring runs around the bay is totally different, once the motors are out of both cars the wiring will unclip and trace back all to one exit/entry point on the fire wall, disconnect from inside and pull it thru, not hard at all. Lots easier then trying to chop, soldier, extend and adding wire's, then more soldiering.
_________________ To many project's and not enough $$$ |
||
| Top | |
||
| Vicky |
|
||
Age: 52 Posts: 9 Joined: 30th May 2017 Ride: Fords bmw toyota landy Location: Port pirie sa |
Is there a easyer way was tld you can but a jump wire in some how
|
||
| Top | |
||
| Vicky |
|
||
Age: 52 Posts: 9 Joined: 30th May 2017 Ride: Fords bmw toyota landy Location: Port pirie sa |
Thank you so very much
|
||
| Top | |
||
| Mad2 |
|
|||
|
{USERNAME} wrote: Is there a easyer way was tld you can but a jump wire in some how other than what has been mentioned ... you 'could' make a separate loom for the engine only. as in running the engine only. would need a J3 tho & at least run a wire for the tacho. do a search for ideas. |
|||
| Top | |
|||
| Vicky |
|
||
Age: 52 Posts: 9 Joined: 30th May 2017 Ride: Fords bmw toyota landy Location: Port pirie sa |
Thank you so very much
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: Google Adsense [Bot] and 34 guests |
