|
mistymtn |
|
||
|
Hi guys
I've had a few drams today i had to change my harmonic balancer & i also cleaned out my throttle body but now my auto is not changing gears poperly after replacing the balancer with a new one put everything back together it starts & runs fine but when i drive it it doesn't change gears until it hits around 3500rpm in each gear & changes hard, you can also feel it kick back down a gear when stopping. is this Limp mode??? or have just knocked something?? i did clean the throttle body out & did have both sensors off the throttle body when i cleaned it if limp mode how do i get it back to normal thanks for all your help guys Cheers Mistymtn |
||
Top | |
AXR88U |
|
|||
|
Try putting a bit of that special conductive grease on the pins in the connection plug.
_________________ ________________________________________
|
|||
Top | |
joolz |
|
|||
|
spray the pugs pins with CO contact cleaner by CRC then a light spray with CRC 2.26 or WD40. If the battery was off for a period of time the KAM may need reseting, this will take about a week of normal driving.
|
|||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 38 guests |