|
| Waggin |
|
|||
|
Andrew J wrote: I was initially thinking of the fact that it was a single tune, and not two.
The Fuel/Spark map is a single tune, however it has been tuned with the BBM switching at 3800rpm. The engine has far different spark/fuel requirements depending on the position of the BBM.
_________________ WAG363: AUII LTD Supercharged 363 Dart Stroker [Supercharged 363 LTD Build] |
|||
| Top | |
|||
| Dellboy999 |
|
|||
|
Waggin wrote: Andrew J wrote: I was initially thinking of the fact that it was a single tune, and not two. The Fuel/Spark map is a single tune, however it has been tuned with the BBM switching at 3800rpm. The engine has far different spark/fuel requirements depending on the position of the BBM. Don't I know it  , running as rich as in the top end and making a whole 81.8rwkw (with stnd manifold I made 97.3 and quite lean) because of the fact 
_________________ Full working BA Shifter now upgraded to BF Shifter. |
|||
| Top | |
|||
| stockstandard |
|
|||
|
Dellboy999 wrote: Don't I know it
, running as rich as in the top end and making a whole 81.8rwkw (with stnd manifold I made 97.3 and quite lean) because of the fact going even more off topic, what fuel reg and computer are you running. Isnt the fuel pressure for EA-ED 250kpa and EF/EL 275KPA (and XR's 300kpa)? If so your injectors will be squirting more fuel than the computers think.
_________________ Stoke me a clipper, I'll be back for Christmas |
|||
| Top | |
|||
| Dellboy999 |
|
|||
|
EA injectors, stock EA computer (yes i know, upgrade it, hence this thread for a start
 ), EL reg 270kpa they are, EF fuel pump.
250 vs 270 aint that big a difference, about 8% higher fuel pressure.
_________________ Full working BA Shifter now upgraded to BF Shifter. |
|||
| Top | |
|||
| sickd |
|
|||
|
so if we run it woth out the butterlfys in it so in long runner mode are we goin to notice much difference in power
_________________ BA XR8 BOSS 260
|
|||
| Top | |
|||
| sickd |
|
|||
|
so are we sure that the bbm is not opended and closed by vacuum and the wires going to iit from the ecu are just sending the ecu a signal to tell it to swap tune over and all this happens at 3800 purly by chance or the vacuum preesure solanoid was made to work at this rpm as they found it was the best time for it to change over
_________________ BA XR8 BOSS 260
|
|||
| Top | |
|||
| Waggin |
|
|||
|
sickd wrote: so are we sure that the bbm is not opended and closed by vacuum and the wires going to iit from the ecu are just sending the ecu a signal to tell it to swap tune over and all this happens at 3800 purly by chance or the vacuum preesure solanoid was made to work at this rpm as they found it was the best time for it to change over
No, the ECU sends 12V to switch a vacuum solenoid. Trust me, i've configured it on an aftermarket ECU
_________________ WAG363: AUII LTD Supercharged 363 Dart Stroker [Supercharged 363 LTD Build] |
|||
| Top | |
|||
| stockstandard |
|
|||
|
pin 15 on the EL ECU according to http://www.fordmods.com/forums/documents.php?doc=42
BTW: EF pinout would be awsome
_________________ Stoke me a clipper, I'll be back for Christmas |
|||
| Top | |
|||
| sickd |
|
|||
|
pin 20 on ef i looked up the wiring diagram
_________________ BA XR8 BOSS 260
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 60 guests |
