|
daendo70 |
|
|||
|
does anyone know how to install and dach clock into an ea falcon eg. wiring.
_________________ it a classic, not plastic and it a really aussie car to boot.
|
|||
Top | |
mk1 |
|
||
|
The wiring shouldn't be too hard, you should only need a positive that is a live wire (check using a test light with ignition off) and a negative.
I have never done it with an ea but it's pretty basic. Cheers. Dave. |
||
Top | |
daendo70 |
|
|||
|
the problem is that there are 4 wires from the clock and i need to know where the go
_________________ it a classic, not plastic and it a really aussie car to boot.
|
|||
Top | |
snap0964 |
|
|||
|
Not knowing if the clock is std Ford or aftermarket, I'm guessing your 4 wires are:
1. Battery Power (always on) 2. Ign Power 3. Lighting Power 4. Earth Earth is usually black, so it shouldn't be difficult to figure out what's what with the other 3.
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
Top | |
ReGiE |
|
|||
|
the plug should be in the back of that little panel for the clock i think
_________________ Gooooone - Eb2 Coon - 143RWKW |
|||
Top | |
JOSE |
|
|||
|
i dont think EA's have the clock plug if it wasnt factory fitted EB-ED do though.
_________________ Because i can. |
|||
Top | |
kermey |
|
|||
|
{USERNAME} wrote: i dont think EA's have the clock plug if it wasnt factory fitted EB-ED do though. it is in mine but i have the Spac II !
|
|||
Top | |
philaddis |
|
|||
|
{USERNAME} wrote: Not knowing if the clock is std Ford or aftermarket, I'm guessing your 4 wires are:
1. Battery Power (always on) 2. Ign Power 3. Lighting Power 4. Earth Earth is usually black, so it shouldn't be difficult to figure out what's what with the other 3. Above is correct. If you do not have the plug, all these can be picked up at your stereo head unit loom!
_________________ ED XR8 Spri-mitatio-nt |
|||
Top | |
Ghia5L |
|
|||
|
Assuming you've bought an EA-D clock (NOT trip computer), all you need to do is remove the blank plastic panel, plug in the clock (there should be a plug + loom behind this panel), and then slot the clock into the hole where the panel used to be.
-Dave- |
|||
Top | |
NudgE^SIKBRO |
|
||
|
the wiring for the clock is there in all EA's
_________________ SIKBRO |
||
Top | |
Selekta |
|
||
|
{USERNAME} wrote: {USERNAME} wrote: i dont think EA's have the clock plug if it wasnt factory fitted EB-ED do though. it is in mine but i have the Spac II !Mine does and it's an Spac S1
_________________ |
||
Top | |
Who is online |
---|
Users browsing this forum: Majestic-12 [Bot] and 8 guests |