|
bozzanalty |
|
||
|
Hi, I've got an EF XR8 most mods have been cosmetic but I have a cat back redback system. I'm only getting mid 16's and 0-100 in 8.2 seconds. Has anyone else run a fairly stock EF or EL to compare? What do you think about the time?
|
||
Top | |
EDXR8 |
|
|||
|
It is a touch slow, I have seen a number of stock EF/EL V8's run mid 15's. Was this actually on the track? Need to get a decent set of extractors on there to let the engine breath, that along with practise should get you at least into the 15's.
|
|||
Top | |
bozzanalty |
|
||
|
It was measured with a g-tech meter. Extractors are next on the cards.
|
||
Top | |
EDXR8 |
|
|||
|
The G-techs can sometimes be a little bit out, until you have a actual track run to compare it with you won't know for sure. They are consistant though (as long as you average the runs in both directions etc) so are a really good indication to mods and lauch method etc.
|
|||
Top | |
EL XR8 |
|
|||
|
Yeah it sounds a little slow to me, you're probably not launching as best as you could perhaps. Maybe a little more pratice?
I was getting a best of 15.5 down the quarter, then i fixed up my cold air problem (I had none) and i am running 15.3. I've got a set of Genie Extractors and an Aftermarket exhaust (Already on the car when i bought it) You should definately be in the 15's even stock i would think. Dave |
|||
Top | |
kissy |
|
||
|
I haven't done much to my car and on a gtech i now average 15.7@90-94Mile, and my 0-100 is about 7.8secs. i stall mine up to about 2000rpm when i launch (auto).
_________________ EFII Fairmont, Low king springs, F1 tint, rebuilt motor, AU XR8 intake, Pacemaker Race Series extractors, 2 1/2" zorst, "free flow cat". Currantly concidering a wade cam!!!
|
||
Top | |
EFNWIKD6 |
|
||
|
i spose its close to what you should run with basic mods. I mean the EL XR8 series 2 in manual runs anywhere between 15-15.5 or so, and an auto i assume a bit slower ie 15.5-16.0 , so an EF XR8 with a 3.23 diff ratio an automatic would be around low to mid 16s seeing as in the early EF & EL stages the XR6's were nippier and they do low 16's or high 15's. Anybody else ?
|
||
Top | |
kato |
|
||
|
My ef xr8 manual has extractors, freed up exhaust and a k&n and i ran a 15.5 with clutch slip in the first three gears!! (must fix that)..
_________________ EF XR8 5spd: 302ci /178rwkw |
||
Top | |
TerroristGHIA |
|
|||
|
Thats about right. My auto dead stock ran 16.2 when i first got it, and that was with no modifications. But then again, mine is a fairmont Ghia with all the fruit and only had 170kw from the factory, and is considerable heavier than an XR8
Brett
_________________ The Terrorist ED Retired due to RUST. |
|||
Top | |
jonbays |
|
||
|
EL xr8's have the 185kw moto and the 3.45 diff and do mid 15's Ef is slower so its about as accurate as you would expect
|
||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 50 guests |