|
| TerroristGHIA |
|
|||
|
Yes, i have a set of 17x7 1/2 steel territory rims that i want to get widened to 9 inches in sydney if possible. Spoke to Waggin about where he got his done and they said they dont do 17's. Any ideas would be helpful. The reason i need this is that i have just purchased a set of 275/40/17 Mickey Thompson Drag Radials in the search for 12 sec quarters. Was told that they will not fit on an 8inch rim and need a minimum of 9inches.
Brett
_________________ The Terrorist ED Retired due to RUST. |
|||
| Top | |
|||
| JOSE |
|
|||
|
just ring up all the engineering workshops in your area, someone will be able to do it.
_________________ Because i can. |
|||
| Top | |
|||
| xr8 dismantler |
|
|||
|
might have trouble getting someone to do the territory rims as the center forms a part of the outer bead then the rest of the rim welds to this .
bit hard to explain but if you look at the rim the center isnt welded in. |
|||
| Top | |
|||
| MRE-50L |
|
|||
|
brett give the guys at tempe tyres a call
they may be able to help you out on that 1
_________________ Chance Favors The Prepared Mind ! |
|||
| Top | |
|||
| TerroristGHIA |
|
|||
|
Will do, thanks guys, might just have to buy some cheep a** 17x9 rims to get it happening
Brett
_________________ The Terrorist ED Retired due to RUST. |
|||
| Top | |
|||
| Interceptor |
|
||
|
any idea if the same "stretching" tricks can be applied to 1 piece alloys?
_________________ Banned |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 11 guests |
