|
| RONIN |
|
||
|
nice
i had the exact same thought, but with little technical talent i am unsure how to get the mesh to hold on to the bar, what method did u use?
_________________ RIP Peter Brock
|
||
| Top | |
||
| fuzion |
|
||
|
I cut it to a size and moulded it in properly and use silicon to hold certain bits in, so basically its in a tight moulded fit and doesnt move or anything..
personally i suggest taking of the bar to do it if you want it to look clean/stockISH. i wanted to use other mesh (round hole one) but the flow wasnt too good |
||
| Top | |
||
| One Drone |
|
|||
|
I think the next thing you should do is get some putty and fill in the number plate holes on the front. I wanted to do it to mine, but kept forgetting to do so. Then paint over it with touch up paint.. Better than two gay holes.
_________________ There are 10 types of people in this world. |
|||
| Top | |
|||
| fuzion |
|
||
|
Too lazy, if all goes well this week ill get the bar resprayed first
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 84 guests |
