|
| CraigsAUXR8 |
|
|||
|
I would give the hot water a try, but first i would take the mesh out and cut a couple of 4x2s to fit (one for the top and one for the bottom)and you would have to pour a couple of liters over it slowly, so it has time to heat up the plastic.
and then when its good and hot, clamp the wood on it with a couple of G clamps. |
|||
| Top | |
|||
| XR~ADZ |
|
|||
|
i dont want to take the mesh out - it was fitted with silicone from the inside by a crash shop - they did a real good job - and if I take it out, Im not sure i'd get it back in as nice.
I like the Idea of some G. Clamps tho - that would still work without taking the mesh out wouldnt it?
_________________ "This is FORD country.... Where on a quiet day you can hear the HOLDENS rusting...." |
|||
| Top | |
|||
| CraigsAUXR8 |
|
|||
|
as long as you can get big enough ones that will reach,
and if you cant borrow any, you could always go and hire some for half a day. they only have to be there until the plastic cools down. |
|||
| Top | |
|||
| wicksy |
|
|||
|
did ya fix your bend mate??
_________________ Now i have a EF XR8 5spd.........mmmmmm 5L |
|||
| Top | |
|||
| XR~ADZ |
|
|||
|
Not yet. Had a busy weekend drinking piss and watching the crows thump port
should get round to it this weekend.... Ill let ya know tho....
_________________ "This is FORD country.... Where on a quiet day you can hear the HOLDENS rusting...." |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 20 guests |
