|
| phongus |
|
|||
|
Hey guys/girls
i replaced my fuel pump last time rite and followed the gregories book and also asked for u guys for some help. in the end it worked and it works well until now. The cap has gone lose and petrol is seeping out since i filled it up yesterday. now the plastic cap has gone all soft becos of the octane and now its a b**ch to unscrew. is it best to get a new cap or just remove that one and put it back in? cheers phong
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| Big John |
|
|||
|
I think you will find it is the O ring that has had it. You did replace it when you did the pump didnt you. When you put the new one in smear it with some vasaline so it wount get court or split.
_________________ XC-GXL 387 12.04 @ 114 |
|||
| Top | |
|||
| phongus |
|
|||
|
yeah i did. but i dunno i think i didn't tigthen it enough so the whole thing has gone loose. thanks mate ill go out and buy a new one. cheers
phong
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| msman |
|
||
|
make a u shaped tool out of some wire, thick wire, that fits on the plastic ring, you will be able to tighten the ring alot better.
_________________ why do u write in here. |
||
| Top | |
||
| MARK.TANIA |
|
||
|
HI I MADE A TOOL FOR THIS I USED A BIT OF FLAT STEEL AND BENT INTO A U CUT GROVES IN THE ENDS AND WELDED A OLD SOCKET ON THE TOP SO I COULD GET A GOOD TIGHTEN ON IT
|
||
| Top | |
||
| phongus |
|
|||
|
well i bought a new o ring and its bloody expensive. 21 bux for a piece of rubber so much rip off. hopefully that one works better. and i tighten it. by the way thanks for the tool thing. i didn't use it but the cover is on pretty tight, hopefully nothing is wrong.
cheers phong
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 33 guests |
