|
| falcon_ef_futura |
|
||
|
gday all,
i have little problem with my car. i just degreased the engine and hosed it off. about 2 hours later i got into my car and i started driving and it was fine. after about 2 kms i started cutting out when i put my foot down and then after that it was driving really rough and idled rough too. i was just wandering if this has happend to anyone else or if someone could shed some light and should i warry about it.... cheers all
_________________ weeeeeeeeeeeeeeeeeeeeeeeeeeeeeeee |
||
| Top | |
||
| Interceptor |
|
||
|
try it in the morning, i'd bet you've got water in something electrical that doesnt enjoy getting wet
_________________ Banned |
||
| Top | |
||
| Chicken |
|
|||
|
Yeh, just give it a bit of time to dry out a little...
_________________ Red goes faster, and chicks drive better |
|||
| Top | |
|||
| Jimmy |
|
||
|
Sounds like you got the dizzy wet. or the coil.
Try not to point Hi pressure water at anything that has wires. and use a compressor to blow out excess water from where the sparks are. |
||
| Top | |
||
| falcon_ef_futura |
|
||
|
oh ok cheers,
so will that just dry out or what?
_________________ weeeeeeeeeeeeeeeeeeeeeeeeeeeeeeee |
||
| Top | |
||
| Interceptor |
|
||
|
yea, it'll dry out on its own
_________________ Banned |
||
| Top | |
||
| ndroo |
|
||
|
yeppers should just dry out, if it still exists tomorrow...then id worry but until then alls good. Lift the bonet, will dry faster.
|
||
| Top | |
||
| falcon_ef_futura |
|
||
|
will it be right to drive or should i aviod driving it till it dries up
_________________ weeeeeeeeeeeeeeeeeeeeeeeeeeeeeeee |
||
| Top | |
||
| ndroo |
|
||
|
well id say if you drive it, it will heat up and therefore not be a prob after a while. Engins are meant to be tough, and the electrics are made with the idea in mind that they will get wet sometimes, i would drive it n not worry about it.
|
||
| Top | |
||
| ArTisT |
|
||
|
if it stll doesnt work properly spray crc in the dizzy near the rotor if still f**k go to kmart and get a rotor and dizzy cap and try that... quite cheap and should solve the problem
|
||
| Top | |
||
| NOCLAF |
|
|||
|
happened to me too about 2 months ago... i left it for 3 days and still wouldnt even start... i ended up replacing the coil.. now if i wash my engine i go for a run and let the engine warm up a bit so any water will evaporate quicker...
_________________ It puts the lotion on its skin.. or else it gets the hose again! |
|||
| Top | |
|||
| joolz |
|
|||
|
Usually the coil cracks where the 2 steel plates bolt to it, water can get in and play havock, thats what happened to mine so i modified the brackets to make the coil sit verticel instead of horizontal, taking the stress off the coil. A new coil for my el 6cyl cost $50 trade. the same coil is used in VT commowhores!
|
|||
| Top | |
|||
| outlawxr6 |
|
|||
|
I had a similar problem with mine, it turned out that the timing was way out from the time i bought it. Once it was adjusted it hasn't played up at all...
_________________ Do it once, Do it right!!!!!! |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: Facebook [Bot] and 49 guests |
