|
| MooseMan |
|
|||
|
My brother put a EA 5spd into his car on the weekend and him and my dad asked me to post on here and ask how to wire it up properly. Its a series 1 EB with the original ECU.
_________________
|
|||
| Top | |
|||
| xpression |
|
|||
|
plug the auto inhibitor switch on ( it has 2 plugs, u only want one of them plugged in and i forget which one (if its the wrong one the car wont start) and set it to the same position as "d"
then it will idle fine |
|||
| Top | |
|||
| Spork |
|
|||
|
I think setting it to Neutral would be a better idea. You might also have to connect a resistor to the temp sensor wires to prevent the trans overheat engine strategy kicking in.
_________________ Manual EL Gli.
|
|||
| Top | |
|||
| xpression |
|
|||
|
naa when u set it to netural it idles higher in anticipation of needing the handle to load if u put it in drive
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 132 guests |
