|
| Krytox |
|
|||
|
G'day,
A mate of mine (who's a member but cant get online) is having trouble with his BEM. He's replaced the dash loom for a Fairmont and has installed the CC and that works fine. However when he was re-programming the new high series BEM to the ECU and Ign. barrel, he gets a Fault code. And after 40 or so minutes the LED Jewel stays ON and No door lock cycle. 1st attemt to start... No go (cranking yes) 2nd attempt Yes. Fires up and all good. remove key and wait a few minutes... it won't start. Im not sure of the code but I think it is: 455. Does anyone have a code book they could please PM me or post with a list of codes so we can get this bastard going! other than that.. everything seems OK. Everything has been checked over, However the BEM wires were cut and replaced, (not sure if soldered) would this have a resistance effect in Programming. Thanx
_________________ Carefree, we may not be number one, but we're up there. |
|||
| Top | |
|||
| dazzat |
|
||
|
Thanx to krytox we fixed the problem, 2 wires were wired wrong
_________________ Love getting ripped off by fellow Ford Modders... 4 to date so far since 2005!!!!
|
||
| Top | |
||
| dazzat |
|
||
|
Thanx to krytox we fixed the problem, 2 wires were wired wrong
_________________ Love getting ripped off by fellow Ford Modders... 4 to date so far since 2005!!!!
|
||
| Top | |
||
| dazzat |
|
||
|
Thanx to krytox we fixed the problem, 2 wires were wired wrong
_________________ Love getting ripped off by fellow Ford Modders... 4 to date so far since 2005!!!!
|
||
| Top | |
||
| dazzat |
|
||
|
ARGGGGGGGGGGGGGGGG triple posting again whats wrong with my comp.... sorry guys
_________________ Love getting ripped off by fellow Ford Modders... 4 to date so far since 2005!!!!
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 38 guests |
