|
| Mac Winter 76XB351GS |
|
|||
|
Gday,
Ive got a C4 and the cap on the dipstick has come loose and I cant tell how far to push it in. How many mm is the top of the cap from the end of the dipstick so I can tack it back where it should be? Thanx
_________________ 76XBGS, 383c, custom crow cam, 4V p&p heads, Isky SS Valve+springs, extractors, 2.5"twins, MSD Ignition, Edelbrock intake, Forged bottom end, Barry Grant 750DP, thermo, discs, toploader, Holley fuel pump, SUPERCHARGED! |
|||
| Top | |
|||
| pinkbits8u |
|
|||
|
i think there is 2 little crimp marks that hold the steel part of cap in that you should be able to see
if you cant see them give me a buzz and ill go and measure for you can you also tell me the length of your dipstick down to the full mark , im having some issues with oil coming out of breather on c4 and wish to confirm its the correct dipstick c4 has the dipstick tube going into the pan |
|||
| Top | |
|||
| Mac Winter 76XB351GS |
|
|||
|
Nah cant see the crimp marks. I'll measure it up for U tomorrow as shes all locked up at the moment.
_________________ 76XBGS, 383c, custom crow cam, 4V p&p heads, Isky SS Valve+springs, extractors, 2.5"twins, MSD Ignition, Edelbrock intake, Forged bottom end, Barry Grant 750DP, thermo, discs, toploader, Holley fuel pump, SUPERCHARGED! |
|||
| Top | |
|||
| pinkbits8u |
|
|||
|
ill do same
|
|||
| Top | |
|||
| pinkbits8u |
|
|||
|
top of bend to steel is 62mm
ththat to small washer on underside of rubber is 17mm WASHER DOWN TO OK LINE IS 523 PART NUMBER ON DIPSTICK IS 76DA 7A02O BA |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 140 guests |
