|
| Wade Cams |
|
|||
Age: 71 Posts: 565 Joined: 8th Nov 2004 Ride: 2011 Kia Optima Platinum Location: Melbourne |
FastFutura wrote: is there a certain thickness that is needed. cos i can get a 2nd hand pair only used a bit, but wanna make sure of the thickness cos it adjusts the lift of the valve dont it?
I'm quoting from memory as l'm posting this from home. There are 3 sizes. All are 1.90mm thick. 11mm, 13mm and 14mm diameter. I forget which diameter goes in which model. Will try and remember to check it out at work tomorrow. Merry Xmas. 9 sleeps to knock-off for holidays time. Chris WADE CAMS |
|||
| Top | |
|||
| FastFutura |
|
|||
|
that would be good cheers man!
_________________ 94 ED Futura, 5spd, RPM clutch,3.27 LSD, PH4480 pacemakers, 2.5'' Supercat, STG 2 Wade1004-112 advanced16degrees, XH intake K&N panel,pedders superlows, Expursuit puter. clearindicators, volvoTT thermofan
|
|||
| Top | |
|||
| Mako |
|
||
|
i picked these up from ford today... i hope they are it!
edit: these are for an EL and according to fords computer these are the "standard size" of 3 sizes. 
Part Number pic (90k) Shim pic large (90k) (images mega compressed for small size) shims measure 11mm wide x 1.9mm thick or 10.97x1.87mm exact 
EDIT: oh and they cost me $39.85 for 12 
_________________ Regency Red EL Fairmont - PH4480 - 2.5" exhaust - High flow cat/muffler - K&N panel filter - Mandrel bent air intake - T series intake - wade 1604 cam - 98 EL XR6 ECU - Whiteline lows - 17" ROH RT's - Koni yellows - DBA Slotted's - Green Stuff pads
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 74 guests |
