|
| voxace |
|
|||
|
About 7% off. But I'm not sure whether this will be up or down.
|
|||
| Top | |
|||
| markr154 |
|
|||
|
voxace wrote: About 7% off. But I'm not sure whether this will be up or down.
Which is better ...up or down?
_________________ Hot Chilli Red EL XR6, 5-spd, JMM DEV 5 enhanced (161 rwkw custom tuned), Eliminator Switch Chip, 18" BA GTP rims, Pedders Superlows, BA XR6 badges, BA Sunroof, Pioneer Stereo, Splits, 6x9's, 10" sub, 700W 6-ch Viper amp.
|
|||
| Top | |
|||
| voxace |
|
|||
|
Well it'd be nice if it shifted at a higher rpm wouldn't it!
|
|||
| Top | |
|||
| Steady ED |
|
|||
|
voxace wrote: Well it'd be nice if it shifted at a higher rpm wouldn't it!
Not really 
I have to back the accel off in mine or I bounce off the limiter a couple of times 
But yours will go the other way mark, if you just do the ECU. It will shift early, I think. That's what my brain is saying anyway. How early, I couldn't tell you, but that ain't a bad thing. Depending on mods, the 6's usually run out of puff up high. I wish mine would shift just after 4500 at full throttle. I need a shiftkit to firm up the shifts, I know it ain't doing it any good to be backing off, therefore initiating a fairly soft shift, then planting it halfway through.
_________________ ED XR8 Sprint - S-Trim, V500, 249rwkw |
|||
| Top | |
|||
| kezz |
|
||
|
Steady ED wrote: voxace wrote: Well it'd be nice if it shifted at a higher rpm wouldn't it! Not really I have to back the accel off in mine or I bounce off the limiter a couple of times . yep got the same prob as you. if i read correctly, if i go back to the 3.08 speedo gear i wont have this prob but the speedo will be out
_________________ Kezz's 5sp Box Car ---> RPD enhanced with a bunch of other stuff |
||
| Top | |
||
| Steady ED |
|
|||
|
Correct.
But then you have to f**k around with a speedo frequency corrector. I'll get an XR ECU one day...
_________________ ED XR8 Sprint - S-Trim, V500, 249rwkw |
|||
| Top | |
|||
| Davehimself |
|
|||
|
is there any way to reprogram the ecu to change the shift points or is that a no go zone?
_________________
|
|||
| Top | |
|||
| Kimley Chaffey |
|
||
|
AdamN wrote: I know each ecu is made for a particular diff ratio... if my car has a different diff ratio, will the speed shown on my speedo be different?
If The ECU came from a 6 and going into a 6 it wont change the speedo readings. The ECU from the police cars makes the following changes. When placed in drive it will remain in third gear under 65ks,this is handy for city driving. It will allow your car to reach its maximum output.a normal ECU shuts down at 3500 revs with a speed of 185ks. what there full out put is i cant help you,just as long as it came from an auto and going into an auto you wont have to change anything else. |
||
| Top | |
||
| Kimley Chaffey |
|
||
|
AdamN wrote: I know each ecu is made for a particular diff ratio... if my car has a different diff ratio, will the speed shown on my speedo be different?
If The ECU came from a 6 and going into a 6 it wont change the speedo readings. The ECU from the police cars makes the following changes. When placed in drive it will remain in third gear under 65ks,this is handy for city driving. It will allow your car to reach its maximum output.a normal ECU shuts down at 3500 revs with a speed of 185ks. what there full out put is i cant help you,just as long as it came from an auto and going into an auto you wont have to change anything else. |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 43 guests |
