Fordmods Logo

Ball joint 

 

Page 1 of 1 [ 8 posts ] 

 
 Post subject: Ball joint
Posted: Thu Jun 01, 2006 8:16 pm 
Getting Side Ways
Offline
User avatar

Age: 39

Posts: 3687

Joined: 4th Mar 2005

Gallery: 23 images

Ride: XR6 Turbo

Location: Taree
NSW, Australia

Hey lads, Driving the EF for the past 2 weeks ive noticed that shes starting to make a little bit of a clunk noise from the drivers side front wheel, Well 2nite I jacked her up and gave the wheel a riggle and its got some play in it, does this meen the ball joint bearing is stuffed? or is it the wheel bearing? any ruff qlue how much this will cost to get fixed? just a ball park figure.


Thanks Lads.

 

_________________

SS Inductions CAI, K&N Filters, M-spec FMC, Turbosmart BOV, 8psi capa tune, X-force cat.

Mods going on: Nizpro springs, bosch 040 pump + Walbro gss341, 600cc injectors, PWR transcooler, 20% Underdrives, 15psi Actuator, Kingspring SSL's, 15psi tune.....More coming

Top
 Profile  
 
 
Posted: Thu Jun 01, 2006 8:20 pm 
Stock as a Rock
Offline

Age: 37

Posts: 130

Joined: 21st Nov 2005

Ride: fairmont ghia

Location: Brisbane
QLD, Australia

i had a clunk noise coming from the front end, it turned out to just be worn sway bar rubbers
Top
 Profile  
 
 
Posted: Thu Jun 01, 2006 10:33 pm 
Getting Side Ways
Offline

Posts: 975

Joined: 15th Nov 2004

Ride: el wagon

Location: melbourne
VIC, Australia

Just jacking up and wiggling the wheel generaly means bearings are loose. The ball joint should be tested by putting a crow bar under the tyre when jacked up, and lifting the wheel and have someone under the car to look for play.

However, Pedders is a good place to go for a $14 (I think) f/e check
Top
 Profile  
 
 
Posted: Fri Jun 02, 2006 8:37 am 
Getting Side Ways
Offline
User avatar

Age: 39

Posts: 3687

Joined: 4th Mar 2005

Gallery: 23 images

Ride: XR6 Turbo

Location: Taree
NSW, Australia

Ok thanks lads.

 

_________________

SS Inductions CAI, K&N Filters, M-spec FMC, Turbosmart BOV, 8psi capa tune, X-force cat.

Mods going on: Nizpro springs, bosch 040 pump + Walbro gss341, 600cc injectors, PWR transcooler, 20% Underdrives, 15psi Actuator, Kingspring SSL's, 15psi tune.....More coming

Top
 Profile  
 
 
Posted: Sat Jun 03, 2006 7:23 am 
Getting Side Ways
Offline
User avatar

Age: 50

Posts: 2705

Joined: 6th Nov 2004

Gallery: 11 images

Ride: 2009 FG XR6 Sedan

Location: Melbourne
VIC, Australia

Pedders ive found to be a rip off!! got a quote for components to lower my car (springs, struts, shocks and camber kit) all up trade they say! $919.00. Went to bursons it came down to $675 with Kings and Monroe. Called a mate in Stawell and im getting it all for $604. Basically get the check done at Pedders but get the parts else were and do it yourself.
Top
 Profile  
 
 
Posted: Sat Jun 03, 2006 11:24 am 
Getting Side Ways
Offline

Age: 47

Posts: 2015

Joined: 9th Mar 2005

Gallery: 4 images

Ride: Territory TX AWD & AUII XLS EGAS

Location: East Kurrajong
NSW, Australia

Have had no issues with the Pedders checks ... much better than places that do the front end checks.

I had a similar clunk ... but I had a power steer rack that was stuffed and needed replacing.

Best to get it checked out and get a report on it.

 

_________________

04 Territory TX AWD - Winter White - optioned up
06 Falcon BFII XLS ute EGAS - Winter White - EGA-54D Version 2

Top
 Profile  
 
 
Posted: Sat Jun 03, 2006 6:28 pm 
Getting Side Ways
Offline

Age: 41

Posts: 1204

Joined: 9th Nov 2004

Gallery: 11 images

Ride: EL Fairmont Ghia V8 Turbo

Power: 303 rwkw

Location: Melbourne
VIC, Australia

with the check though, is there any way they say that we can't let you drive it out because it's unsafe, therefore becomming committed to get the work done there?

i've thought about getting the cheap check but don't want them to do the work...

- anyone had this happen before?

 

_________________

EL Fairmont Ghia V8 Turbo 303rwkw
{DESCRIPTION}

Top
 Profile  
 
 
Posted: Sat Jun 03, 2006 6:51 pm 
Getting Side Ways
Offline

Age: 47

Posts: 2015

Joined: 9th Mar 2005

Gallery: 4 images

Ride: Territory TX AWD & AUII XLS EGAS

Location: East Kurrajong
NSW, Australia

I have had a couple of my cars done there .... they gave me a report and told me I NEEDED several things done on my car immediately. I said "Thank you for letting me know about it ... I'll get it done when i have funds to pay for it. And I took it to my preferred repairer to get the parts fixed at a later date.

They handed me my keys back and advised not to drive the vehicle much.

They cannot keep your car ... otherwise you can get the police around there and charge them.

But I have never had an issue with Pedders or even Jax for this matter when it comes to safety checks ... they get you to sign a waiver form stating they have informed you of urgent repairs and you opted to drive out of there .... just so they are covered in case of equipment failure on your vehicle.

 

_________________

04 Territory TX AWD - Winter White - optioned up
06 Falcon BFII XLS ute EGAS - Winter White - EGA-54D Version 2

Top
 Profile  
 
Display posts from previous:
Sort by  
 Page 1 of 1  [ 8 posts ] 

Who is online

Users browsing this forum: Google [Bot] and 43 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

 

 

It is currently Fri Dec 27, 2024 4:44 am All times are UTC + 11 hours

 

 

(c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names