Fordmods Logo

1997 El falcon Full Service 

 

Page 2 of 2 [ 23 posts ] Go to page Previous  1, 2

 
Posted: Thu Aug 10, 2006 5:36 pm 
Fordmods Newbie
Offline

Age: 40

Posts: 16

Joined: 29th May 2005

Gallery: 2 images

Ride: EL Falcon

Location: perth
WA, Australia

How much for a thermostat and what do I need ??? I know very basic Mechanics although I will have someone helping me when I do it
Top
 Profile  
 
 
 Post subject: caster / camber kit
Posted: Thu Aug 10, 2006 6:21 pm 
Fordmods Newbie
Offline

Age: 62

Posts: 15

Joined: 19th Jul 2006

Gallery: 6 images

Ride: ZH Marquis

Location: Tamworth
NSW, Australia

hey mate a caster / camber kit installed with a wheel alignment should cost you around $350.00...Most tyre stores should be able to fit it and it does make a difference on tyre wear as i have one on my EL...Maybe if you get the tyres and kit at same place they might cut you a deal.?

 

 

Attachments:
tats el.jpg
tats el.jpg [ 34.45 KiB | Viewed 143 times ]
Top
 Profile  
 
 
Posted: Thu Aug 10, 2006 8:33 pm 
Getting Side Ways
Offline

Age: 39

Posts: 972

Joined: 6th Feb 2005

Gallery: 6 images

Ride: XHII pano, Landau

Location: S.E Subs
VIC, Australia

Dont use synthetic oil in your car

 

_________________

Automatics only come in assult riffles
---------------------------------------
www.aussiecoupes.net

Top
 Profile  
 
 
Posted: Fri Aug 11, 2006 3:49 pm 
Fordmods Newbie
Offline

Age: 40

Posts: 16

Joined: 29th May 2005

Gallery: 2 images

Ride: EL Falcon

Location: perth
WA, Australia

Why shouldn't i use synthetic oil ?????
Top
 Profile  
 
 
Posted: Fri Aug 11, 2006 4:09 pm 
Getting Side Ways
Offline
User avatar

Age: 44

Posts: 651

Joined: 5th Nov 2004

Gallery: 3 images

Ride: falcon V8

Power: 213 rwkw

Location: clayton
VIC, Australia

a tip on the belt for your car it's call a 6pk2375 If you any where near kewdale you could get the belt from Statewide bearings think the address is 67 kewdale rd kewdale they have them in stock and tell them that you where quoted about $20.00
Top
 Profile  
 
 
Posted: Fri Aug 11, 2006 4:20 pm 
Stock as a Rock
Offline

Posts: 149

Joined: 23rd May 2006

Ride: NL Fairlane

Location: Melburn!
VIC, Australia

Phaz3 wrote:
How much for a thermostat and what do I need ??? I know very basic Mechanics although I will have someone helping me when I do it


Sorry dude I didnt check back.

Well the thermostat is a very simple thing to replace, you will want to drain your coolent a bit, it drain it all and replace with new stuff.

But the steps I used were as follows.

Locate the thermostat housing(facing your engine bay its on the right side of the head and has a big pipe that goes to the radiator).
You will have to remove the belt cover aswell, to get at one of the bolts, once the fan cover is off, then you need to undo the double ended bolt from one side of the thermostat housing and remove the bolt from the other side, now it should be easy to remove. If it is stuck a little use a screwdriver to break the seal.
Once off you will see the thermostat, it should look just like the one you are replacing it with, pull it upwards(might need to use the screwdriver again to get it to pop out) then just drop the new one in there and bolt it all back up.

Cheers
Top
 Profile  
 
 
Posted: Fri Aug 11, 2006 4:57 pm 
Fordmods Newbie
Offline

Age: 40

Posts: 16

Joined: 29th May 2005

Gallery: 2 images

Ride: EL Falcon

Location: perth
WA, Australia

Sorry How Much would a thermostat cost ?
Top
 Profile  
 
 
Posted: Sun Aug 20, 2006 11:50 pm 
Fordmods Newbie
Offline

Age: 55

Posts: 2

Joined: 14th Apr 2006

Location: sydney
NSW, Australia

Make sure get the temp correct on the thermostat which is engraved on it. Ford uses 90degree ones but i use 82degree Trident branded one which runs my engine slightly cooler without any probs. I would also read a bit on flushing the entire transmission with a new filter kit . This transmission flush includes the oil change inside the torque converter also. This may cost you abt $250 in a garage but $350 at Ford dealership. Make sure the garage has a circulating flushing pump for the oil in tranny. This is a good insurance policy for those future tranny probs.
Top
 Profile  
 
Display posts from previous:
Sort by  
 Page 2 of 2  [ 23 posts ]  Go to page Previous  1, 2

Who is online

Users browsing this forum: No registered users and 116 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

 

 

It is currently Tue Nov 26, 2024 11:51 am All times are UTC + 11 hours

 

 

(c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names