How do I reset the ECU in my 91 EB after I have replaced the faulty sensors that were giving me grief??

Any help?

Start by reading the FAQ sticky

(unplug the battery for 1/2 an hour or so)

Man sticky's are a waste of time, we put them up but nobody reads them.
Everyday there is still an exhaust / extractor question, or the big one.... "Which snorkle" LOL.

I just hope that somebody reads them...

how about giving people who start threads that are answered in a sticky a set of l-plates in their avatar for a week?

NOTE DO NOT TOUCH THE ACCELLERATOR DURING ANY PERIOD OF THE ADAPTIVE PROCESS.
The correct way to set idle speed after battery disconnection is:
1. Run engine until operating temp reached and thermostat opened.
2. The engine should then be idled for approx 1 minute in each of the following conditions (total idling time approx 4 minutes)
3. Neutral with all electrical loads OFF.
4. Neutral with Air conditioning ON.
5 Drive with all electrical loads OFF.
6. Drive with Air conditioning ON.


After all this has been done then proceed to go on and to do these steps which actually set the TPS values;

5. *To set the closed throttle reference position, place the transmission
in Drive, Air con off, and let the engine idle for a minimum of 1 minute.
6. Next, set the wide-open throttle reference position by turning the
engine off- but leave the ignition switch to the "ON," position, ie;Idiot lights on etc, then press the accelerator
pedal to the floor and hold it their for 1 minute, minimum.
7. Then Place the gear selector to Park and switch off the ignition.
8. Drive the vehicle and check for proper shifting patterns.

LOL i wish we could, then rename the sticky threads to L platers click here!

can you tell me how to run the diagnostic on the ecu or where you got the info, i have been searching for days and i havent found a thing

http://www.fordmods.com/forums/documents.php?doc=52

scroll down 1/3 page