|
| Fairmont99 |
|
|||
|
{USERNAME} wrote: 2031 cam for 1.7 rockers
2030 cam for 1.6 rockers Both cams are pretty similar in specs and will go quite well with a 5.0 - and give you a little more room to move when you start doing a few more mods. The 2030 is slightly more aggressive than the 2031 but can be used with satndard ratio rockers. Shane So can a 2030 cam be put straight in an AU without any other modifications? Still need new springs?
_________________ Hope is the first step on the road to disappointment. |
|||
| Top | |
|||
| MrLandau |
|
|||
|
The springs will need to be uprated on both cams. Both use the same crane valvespring set, locks and retainers.
_________________ Weapons of choice |
|||
| Top | |
|||
| EBXR8380 |
|
|||
|
What sort of inlet and heads are you using or intend to use ????
SVO and the Crane cams mainly work on aftermarket or ported GT40 heads...The SVO cams have power from 2500 rpm on..Imo there are cams that work under that rpm and with our heavy cars here work better..The other option is to change final drive to say 3.7 then these cams would be on sweet spot most the time...
_________________ As in ZOOM 126 edition |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 47 guests |
