I need a pic of which way the 2 airbag wires hook up into the plug behind the airbag inside the steering wheel. Mine ripped out somehow and i have to put them back in cuz the flashy light is driving me nuts......

Thanks in advance

Shouldn't be to hard mate, the plug only fits in one way

i dont have a pic of the inside.
the air bag light will still flash after hooked back up
to solve

Turn the ignition on but dont start the engine
Wait for the code to be displayed once, so the five flashes, then a pause, then the 2 flashes.
Connect your short out wire to the far bottom left pin (ground) and the first pin on the top row after the plastic divider from the left.

The car should beep 5 times. After the beep, remove the wire, and turn the ignition off.
Now, here's the tricky bit. The computer for the airbag actually logs a code saying you repaired the low voltage/broken fuse' by grounding it. So, after you clear code 52, code 53 appears.
You then have to clear code 53 following the above steps. If code 52 doesn't clear using that method above, check your fuse again.

So, clear code 52, then clear code 53, and the airbag should stay off for good, unless your fuse keeps blowing because of a short circuit somewhere in the airbag system.

No i think u guys misunderstand. The plug is still connected to the socket in the steering wheel and the airbag is sitting on my backseat with 2 wires hanging out of it with no connector. Being the airbag i dont want to hook them up the wrong way round into the connector, im a lil worried about the airbag blowing up.

send me a pm tomorrow and ill take a photo of mine for you seeing as im outting my steering wheel back on.