|
| creeture3 |
|
||
|
G'day therillseekers : I, too, have a Tickford system
 Between the converter and the airbox runs a balance pipe, which is plastic, about 25mm I.D., and mine has a hole in it. ( I have it sticky-taped up at the moment :lol)
I have priced a new pipe from Fraud, and they want some astronomical money for a new one. Somewhere around $50!!! 
Question: has anybody had to replace one of these, and what did you use. I have searched high and low, and cannot find a suitable replacement. The pipe has to be flexible enough to cope with some very tight radius bends. |
||
| Top | |
||
| Disco Frank |
|
|||
|
use some heater hose or fuel line hose
all it is there for is iirc to allow atmo pressure to the conveter
_________________ RIP SCOTT |
|||
| Top | |
|||
| twr7cx |
|
|||
|
theres no pressure in it, any hose the right size will do.
|
|||
| Top | |
|||
| creeture3 |
|
||
|
I understand that there is no pressure in it, and I can use heater hose etc, but the problem is firstly, finding the right ID/OD., and second, finding a hose that will cope with a sharp radius bend without kinking, as a heater hose will. the final bend at the airbox is very sharp, and any hose i try to use there simply kinks and blocks the air flow.
|
||
| Top | |
||
| Disco Frank |
|
|||
|
simple
get a piece of the old hose and go the the auto shop and tell them for the bend 2 options 1, make the hose longer and use a differnt route through the engine bay 2, get some 90deg plastic poly bends from bunnings ( ones used on retic pipe ) and hose clamp each side
_________________ RIP SCOTT |
|||
| Top | |
|||
| GTBob |
|
|||
|
{USERNAME} wrote: simple
get a piece of the old hose and go the the auto shop and tell them for the bend 2 options 1, make the hose longer and use a differnt route through the engine bay 2, get some 90deg plastic poly bends from bunnings ( ones used on retic pipe ) and hose clamp each side Nothing like bush mechanics to get the problem sorted and probably a lot cheaper than FRAUD  
_________________ Rotten Old Revhead!!! XW GTHO + EF ex cop car (exractors 2.5 cat back zorst !6" Simmons K&N +airbox mods Lowered with Bilstein shocks+Whiteline Bars NEXT THING Swap HO for GTP or Ferrari! |
|||
| Top | |
|||
| Disco Frank |
|
|||
|
your welcome
_________________ RIP SCOTT |
|||
| Top | |
|||
| rushed |
|
|||
|
whats this balence pipe for?
i dont have one, just a hole in the convertor for it. |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 8 guests |
