|
| OBS35N |
|
|||
|
hey everone
I was just wondering if anyone could tell me how much a cam angle sensor for an ef should cost and how many hours it should take a mechanic to put it in cheers
_________________ OBS35N is gooonnnneeee.
|
|||
| Top | |
|||
| MARK.TANIA |
|
||
|
about 150 to 180 and about 30 mins to install you can do it your self
|
||
| Top | |
||
| OBS35N |
|
|||
|
what's involved in installing it?
_________________ OBS35N is gooonnnneeee.
|
|||
| Top | |
|||
| Krytox |
|
|||
|
A rivet a spanner and TDC!
Rotate the device till you can see a spot on the side to put in a nail/rivet/drill bit or whatever. make sure the engines on TDC (compression stroke). Press and rotate in. Tighten. Remove nail. Install connector. Bobs ya sis.
_________________ Carefree, we may not be number one, but we're up there. |
|||
| Top | |
|||
| MacGyver |
|
|||
|
Check online, they are about $130. Install is the same as installing a dizzy. Now that may or may not help you, LOL.
cheers Scott
_________________ If it doesn't fit, jam it. If that doesn't work use a hammer. - Engineers Motto |
|||
| Top | |
|||
| Krytox |
|
|||
|
ohh yeh, if your installing it urself... don't force it down
As its on a worm drive and also theres a shaft for the oil pump which a hex shape.. A few goes and it'll slot in.
_________________ Carefree, we may not be number one, but we're up there. |
|||
| Top | |
|||
| OBS35N |
|
|||
|
where is it located on the engine?
_________________ OBS35N is gooonnnneeee.
|
|||
| Top | |
|||
| OBS35N |
|
|||
|
bump
_________________ OBS35N is gooonnnneeee.
|
|||
| Top | |
|||
| falcondave |
|
|||
|
It's located on the inlet side of the engine near the front. (where the distributor would sit)
When I ordered a replacement they only sent the actual top "cap" which has the sensor mounted in it. This can easily be removed with the body of the unit still in - two 7mm bolts I think. It is easier if you remove the snorkel for the air box. This worked for me BTW. If you want to remove the whole thing shaft and all then you need to unbolt and remove the bracket that holds it in which is 1 bolt only. Then follow what Krytox said.
_________________ "My theory is that the universe is made out of stupidity because it's more plentiful than hydrogen" - Frank Zappa |
|||
| Top | |
|||
| EBGizmo |
|
|||
|
Where are you sourcing this from? I tried Ford and Bosch, and they both said they don't sell/make them anymore.
_________________ EF II Sedan
|
|||
| Top | |
|||
| MacGyver |
|
|||
|
I lied, they are $120.
http://www.injectacarb.com.au/advanced_ ... &x=57&y=16 cheers Scott
_________________ If it doesn't fit, jam it. If that doesn't work use a hammer. - Engineers Motto |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 6 guests |
