|
| ebs_4l |
|
||
|
{USERNAME} wrote: turn wheel the hall effect sensor is on and set it on 26degrees and then set the base to 60 degress BTDC or other way around i cant remember
yes, that is what is necessary for perfect tfi integration on an autronic SM4, the whole issue is caused by where FORD decided to set the leading edge of the tfi teeth. Pretty much all aftermarket ecu's work best with a cylinder pulse trigger at 60BTDC, and a std tfi wheel triggers at 10BTDC from memory. this is less than optimal way to run a system, so you move the leading edge of the sync tooth to trigger through the hall at 30deg (dizzy btdc)/60BTDC crank. and set your cylinder i/p lead offset at 60deg they do work (as fritzz hasnt touched his tfi) in std form, but timing moves around too much
_________________ EB 4L, 8.4:1, R154, GT4202r, 4in exhaust, Greenslade Engineering exhaust manifold, plenum chamber, 90mm throttle, Garrett W2A cooler, Surecam custom, autronic SM4, Bosch 120lb, Crane HI-6, LX-92, LM-1, Turbosmart Reg, 2x bosch 044, turbosmart 48 gate. 470kw+ @ 18PSI |
||
| Top | |
||
| EBXR8380 |
|
|||
|
The EMS needs free upgrade to run dis systems..
It seems there's more backup with Wolf in Victora And more backup with EMS in NSW... For fitting oil drain check this Vortech site... Scroll down to page 14... [ from memory] http://www.vortechsuperchargers.com/pdf ... A218im.pdf
_________________ As in ZOOM 126 edition |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 41 guests |
