|
| starkers06 |
|
||
|
can anyone tell me a rough price that it would cost to get a ba xt lowered to street legal
|
||
| Top | |
||
| punktured |
|
|||
|
Here's a link to prices for doing it properly, otherwise you can get your springs compressed (or whatever they do) at tyre factory for around $350 if your on a budget. Your best bet would be to get new springs and shocks as your stock shocks wont last too long once lowered, i found that out the hard way
http://www.aussiecar.com/fordsuspension.html P.S Check with your insurance to see how low you can go. My old insurance cancelled mine because i went lower than 30mm which was against their policy. Mark |
|||
| Top | |
|||
| eb_guy888 |
|
||
|
well aparently (someone told me and a few forum guys I know have had it done for ages no problems).. if you get it lowered only about an inch or so, so that its a nice level you dont need to get shocks aswell, just springs.
If you just want springs theres good dobinson springs on ebay for cheap |
||
| Top | |
||
| punktured |
|
|||
|
My ute went down around 2" (if not more) at the back so i was basing it on that, and i thought being a xt it would be a big drop (compared to a XR)
|
|||
| Top | |
|||
| starkers06 |
|
||
|
it says on aussie car 25 - 30mm lower than xr is that lower than a stock xr or will it lower it that much
|
||
| Top | |
||
| surfn |
|
||
|
Front & Rear springs, app' 20mm lower than xr,s, shocks not essential, fitted and 4 wheel aligned approx $650.00
_________________ "In my opinion, my opinion is better than yours" |
||
| Top | |
||
| surfn |
|
||
|
Those prices on that link are very comparable to a leading suspension group around australia that may\may not use a bull as an icon.
_________________ "In my opinion, my opinion is better than yours" |
||
| Top | |
||
| starkers06 |
|
||
|
yeah i know mate got a quote from them aka pedders about 900 for just springs and around 1900 for springs and shocks
|
||
| Top | |
||
| punktured |
|
|||
|
Well you need a chamber kit at the front otherwise you could get wear on the inner edge of your tyres. Craig @ ACE uses top quality stuff, the chamber kit alone is around $400 and takes minutes to adjust and he uses king springs.
I also went to pedders and to be honest they were a useless lot, could have just been the store i went to but the guy had no idea. He didnt really know how to lower a ute and said i'll need lowering blocks and it would cost me over $1000 all up 
|
|||
| Top | |
|||
| SlickNCGhia |
|
|||
|
camber kit $400
 i need one of them as mine is out a fair bit after chucking 17's on (and not even lowering yet) after a wheel allign they said the camber was out a fair bit. it wanders a little and vibrates at hwy speed.
is there any kits or places that would be a bit cheaper. Thanks Ben
_________________ NC Fairlane Ghia. AU engine. Pacemaker 4499. 2.5" Redback Zorst, tints, red dash. 17in ba xr (e-series). Suzuki Across (suzi) Sexy in Black |
|||
| Top | |
|||
| punktured |
|
|||
|
Ye there are cheaper ones, craig just likes to use good stuff and doesnt cut corners
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 51 guests |
