|
| HiBoost |
|
||
|
what is the stock boost the bottem end can handle (stock bottom end)?
_________________ 4LTR-JET: 9.1 @150mph!! |
||
| Top | |
||
| Jim Beam |
|
|||
Age: 35 Posts: 3505 Joined: 1st May 2005 Ride: EB Fairmont Location: Northern Suburbs, Adelaide |
Im pretty sure CHEF's old ED was on 14 psi on a completely stock engine.
_________________ Doin it for Scotty. |
|||
| Top | |
|||
| fritzz |
|
|||
|
20psi+ with the right compression and good tune.
_________________ # 1997 EL Falcon GLI - 600+rwkw |
|||
| Top | |
|||
| HiBoost |
|
||
|
{USERNAME} wrote: 20psi+ with the right compression and good tune.
LOL U seriouse? 20+ PSI?
_________________ 4LTR-JET: 9.1 @150mph!! |
||
| Top | |
||
| MoNGooSE |
|
|||
|
CHEF is mad is mad though...
_________________ EF GT6 - 129.4rwkw - Feautured in Street Fords Issue #77 |
|||
| Top | |
|||
| MoNGooSE |
|
|||
|
Pyroay wasn't comfortable running his any higher than 16psi with standard bottom end and got just over 300rwkw off that
_________________ EF GT6 - 129.4rwkw - Feautured in Street Fords Issue #77 Last edited by MoNGooSE on Sun May 06, 2007 4:08 pm, edited 1 time in total. |
|||
| Top | |
|||
| MoNGooSE |
|
|||
|
{USERNAME} wrote: 20psi+ with the right compression and good tune.
Not for long with a completely standard bottom end... And you would want a far from standard head to deal with that boost
_________________ EF GT6 - 129.4rwkw - Feautured in Street Fords Issue #77 |
|||
| Top | |
|||
| Tocchi |
|
|||
|
stevoperth (514.8 rwhp eb falcon) is running a stock bottom end IIRC
|
|||
| Top | |
|||
| fritzz |
|
|||
|
im not saying its the ringt thing to do, but it will take it.
thats if u can get the comp low enough with stock pistons. there is also a supercharged el xr6 here in perth that has around 440rwkw and runs 10.1's down the 1/4 witch still has the stock bottom end. just remember that ford pistons are already high silicon cast, witch is what most of these guys are running eg tufed6 460rwkw 21psi
_________________ # 1997 EL Falcon GLI - 600+rwkw |
|||
| Top | |
|||
| stockstandard |
|
|||
|
think this is almost an impossible question to answer
by stock bottom end do you mean stock CR or are you going to decompress (cut into chambers or thick gaskets)? how long do you want it to last for? what sort of engine management will you have (state of tune makes a big difference). Boost is a measure of restriction, so the more efficient your engine is (intake, head, cam, exhaust) the less boost you can safely run.
_________________ Stoke me a clipper, I'll be back for Christmas |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 41 guests |
