|
insensate |
|
||
|
I've put a new neutral switch and replaced the bushes in the Auto gear shift column. but for some reason i can't get it to start without pushing the gear shift forward...
does anyone know what the problem is... i've tried adjusting it, cant get it to sit right.. could it be something in the gearbox itself? or am i just not adjusting it right? Last edited by insensate on Mon May 14, 2007 3:38 pm, edited 1 time in total. |
||
Top | |
bluecube |
|
|||
|
have you done the drill bit alignment procedure for the shift bar which connects to the gearbox? If you dont know what I mean then get a gregories manual and it explains it.
_________________ Sold my EB
|
|||
Top | |
insensate |
|
||
|
i know what you are saying... you put the drill bit into the hole underneath on the gearbox..
they do line up... but i still have to push the lever forward to get it to start |
||
Top | |
xpression |
|
|||
|
pull the inhibitor switch off and clean the metal where it goes onto the selector shaft with a wire brush and try it again
|
|||
Top | |
smoke_ |
|
|||
|
just align it bit by bit. a hoist helps though.
_________________ NEW RIDE - FPV FG F6 6spd Auto. 12.26@114MPH, 1.88 60FT on Cheapy Tyres with 38PSI - Stock except K&N filter! |
|||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 59 guests |